Installation Instructions - Kohler New Zealand

11. Remove the cap from the interface cable and connect the interface to theinterface cable.12. Carefully feed the connection through the hole in the wall sleeve and into thewall cavity.13. Make sure that the gasket is in place on the interface.14. Slide the body of the interface into the sleeve.15. Firmly press on the interface until it snaps into place.16. Install the control knob.Complete the InstallationPower SupplyScrewsPower SupplyOptional ExternalInterface CableGrommetsInternal InterfaceCableDoorTabClipRetainingScrew1. Release the retaining screw.2. Press the clips to release and open the door on the valve.3. Connect the interface cables to the valve.4. Connect the power supply to the valve.5. Make sure that all the moulded grommets are in place before closing thedoor.6. Close the door and press on the tabs until the clips snap into place.7. Secure the retaining screw.8. Connect the power supply to the 3 amp switched fused spur box.Check the Installation1. Turn on the water supply to the valve.2. Check all connections for leaks and make any adjustments necessary.3. Turn on the main power supply. You should hear the valve power up and thepower icon on the user interface will be lit with a green pulsing light.4. If not already complete, set up the interface. Refer to ’COMMISSIONING’.9 1065922-A2-B