Installation Instructions - Kohler New Zealand

More documents

Recommendations

Info

Troubleshooting Table (continued)Symptoms Probable Cause Recommended ActionB Water outlet pressure is low. B6 Blend temperature drift ortemperature cycling.7 Maximum blendtemperature too hot or toocold.CFluctuating flow.D If none of the above actionscorrect the symptom, the valverequires servicing.A Fluctuating water temperature.BHot water supply temperaturefluctuation.If none of the above actionscorrect the symptom, the valverequires servicing.Incorrect maximumtemperature setting.If none of the above actionscorrect the symptom, the valverequires servicing.8 Continuous flow. A System will not switch off.9 Water leaking from thevalve.CAUTION: Risk ofpersonal injury orproduct damage.Turn off the main powerand water supply.10 Massaged mode shutsdown but water continuesto run from showerhead(s).11 Hot water only, the valveshuts down.CABA Connections not secure.B Seals are worn or damaged.C Internal leak.A Unequal flow rates betweenvalve outlets.A Hot and cold lines arereversed.CDABCABAABCCheck that the flow rate is ator above the minimum raterequired. Refer to the“Specifications” section.Verify that the dynamic inletpressures are withinspecifications. Refer to the“Specifications” section.Contact your authorisedKohler service representative.Check the inlet temperaturedifferentials and verify they aresufficient. Refer to“Specifications”.Check and make adjustmentsas needed.Contact your authorised Kohlerservice representative.Refer to the “User InterfaceHomeowners Guide”.Contact your authorised Kohlerservice representative.Turn off the water and powersupply and contact yourauthorised Kohler servicerepresentative.Check all connections. Makeadjustments as needed.Order a seal service pack andreplace all seals.Unit requires overhaul. contactyour authorised Kohler servicerepresentative.A Revise installation to have anequal bodyspray to valve outletratio for all bodyspraysinstalled. Use bodysprays withthe same flow rate.A Reverse the hot and cold lines.1065922-A2-B12
spare parts1042634Wall Sleeve1053394Tab1007936Screw1054397** (Horizontal)1054399** (Vertical)Control Panel1042627Gasket1042629**Ring10452518-Pin Cable Assembly69944Suction Cup10452524-Pin Cable Assembly**Finish/colour code must be specified when ordering.13 1065922-A2-B
Page 1: Kohler DTV Digital InterfaceInstall
Page 10 and 11: 5. At the main menu of the interfac
Page 14 and 15: dimensions1/2" (1.3 cm) Min ClampAr
Page 16: Customer CareKohler Co. warrants it

Installation Instructions - Kohler New Zealand

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?