Datasheet - Augier

6.2 Remote Control ModeSwitch Sn on position “Remote”.Selection of circuit by wire control, Jbus RS485/RS422 or MODBUS TCP.(see#CONTROL AND MONITORING) Interlocking: All selection or deselection by remote control cause the dry contact S1-S2 to open for an average time of 200ms. This contact, inserted into the CCRinterlocking loop, force it to stop during the selection or deselection of circuit.Switching is done when at current 0.6.3 Mains supply LossIn remote control position, the removal of 48Vcc supply (or other voltage) of C1 orCx, or the removal of the main supply, or the removal of the two voltages, causes theswitching on (Lamps “ON”) of the two circuits, but don’t stop the CCR (by interlockaction)In local position, the removal of the mains supply have the same effect.What means that whatever the mode (local or remote control), the removal of themains supply (whether the control voltage is present or not), causes the CCR to runwith all circuits energized.7 Alarm indicationA signal light labelled “ALARM” is present in front of the cubicle.This light lit for 2 seconds after power on and must be off after the 2 seconds.During normal use, the “ALARM” light must be off. It will light on in case of interface boarddefault.IMPORTANT NOTICE :This control inputs configuration, as other configuration elements, are set in factoryaccording the kind of remote control board and the type of control supply.60 21362 CIRCUIT SELECTOR Installation & Maintenance Page 8 / 32