Datasheet - Augier

2.2 EEC directivesThis equipment complies with the requirements of EC directives :• 89/336/EEC, 92/31/EEC and 93/68/EEC with regard ofElectromagnetic Compatibility• 73/23/EEC with regard of Low Voltage Equipment3 OVERVIEW:Circuit Selector is intended to provide two alternate circuits selection. The power relays andinterlock to avoid commutations in charge are driven by the CS electronic.It provides “local” and “remote” control, according the choice of local switches present onthe front door of the cabinet. The described version is compliant with ICAO requests andIEC standards.The circuit selector can de ordered in compliance with FAA AC150/5345-5. For thatexecution, the selector provide double HV relays for each circuit, and can be reversed (letterR at the end of the P/N, see: #ORDERING INFORMATION) for manual switch-overoperations.The 2 way circuit selector SC2-A is presented in the form of an indoor type cubicle, madefrom painted metal sheet, external dimensions being H 700 x L 500 x W 300 mm.The connection terminals can be accessed by opening the door (which as 2 “double barred”catches) using the key delivered with each cubicle.On the cubicle door there is a switch (type “turn”), with 3 different positions, which allowsthe choice of the function mode or of the CS. It equally supports the status signal lights foreach circuit.4 CONFIGURATION:The circuit selector can be alternate or simultaneous and the circuit selector can support 2 to6 ways.It is possible to check and change the configuration using INTERMODBUS software tochange values in the Jbus table (see #INTERMODBUS SOFTWARE).SELECTOR TYPE CONFIGURATIONSelector type Jbus address Slave Id Bit 7 to Bit 15 Bit 6 Bit 0 to Bit 5Alternate 69 250 X 0 XSimultaneous 69 250 X 1 XNUMBER OF CIRCUITS CONFIGURATIONCircuits Jbus address Slave Id Value2 to 6 197 250 2 to 660 21362 CIRCUIT SELECTOR Installation & Maintenance Page 5 / 32