Datasheet - Augier

More documents

Recommendations

Info

9 INTERMODBUS SOFTWAREThe software “Intermodbus” is provided with the selector. Using this software connected tothe RS232 link, it is possible to read or modify a value in the Jbus table.9.1 RS232 cableTo communicate with the selector, it is necessary using a crossed RS232 cable.<strong>Augier</strong> reference cable: 30 081379.2 Intermodbus using9.2.1 Communication parametersPort: computer serial link port numberBaudRate: serial link speed: value ataddress 26 (see #Serial link parameters)Default value: 9600 Baud60 21362 CIRCUIT SELECTOR Installation & Maintenance Page 20 / 32
9.2.2 Read valueFor example, reading the value at address 0with supervisor id (250), the result is 128(selector in remote mode, see#Local/Remote status)9.2.3 Write valueFor example, modifying the salve id of theselector (see #Serial link parameters).Slave Id was 1 become 2 writing the value2 at address 25 with supervisor id (250),60 21362 CIRCUIT SELECTOR Installation & Maintenance Page 21 / 32
Page 1: AUGIER SA.1 ère avenue - 2243 - BP
Page 4 and 5: 1.2 DisclaimersThis manual could co
Page 6 and 7: 5 INSTALLATION:Cubicle: It can be f
Page 8 and 9: 6.2 Remote Control ModeSwitch Sn on
Page 10: 8.1.2 Wire remote control with INTE
Page 14 and 15: 8.5 RS485/RS422 Serial Link configu
Page 16 and 17: 8.5.3 Serial link parametersThe asy
Page 18 and 19: 8.7 CS control & monitoring using s
Page 22 and 23: 10 ORDERING INFORMATIONThe Circuit
Page 24 and 25: SELECTOR JBUS TABLEAdr. R/W Mode Me
Page 26 and 27: Adr. R/W Mode Memory Label Detail B
Page 28 and 29: 15 PresentationType FAA, 2 ways :Ty
Page 30 and 31: 60 21362 CIRCUIT SELECTOR Installat
Page 32: 60 21362 CIRCUIT SELECTOR Installat

Datasheet - Augier

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?