Datasheet - Augier

More documents

Recommendations

Info

8.5.3 Serial link parametersThe asynchronous serial links are defined as follows:Preferred parameters : 9600 baud, 8 data bits, 1 stop bits, no parity.JBUS protocol with Id=1 at delivery.It is possible to change the speed and the ID in the “Serial Link” menu:• Speed: 2400-4800-9600-19200 Baud• ID: 1 to 249These changes are active after a device reset (mains disconnection).The 2 serial links access to the same jbus table with the same priority (the last order is theone taken).i The JBUS table is defined in #Jbus tableIt is possible to check and change the slave id and speed using INTERMODBUS software tochange values in the Jbus table (see #INTERMODBUS SOFTWARE).SLAVE IDJbus address Slave Id Default value Possible value25 250 1 1 to 249SPEED SETTING (Bauds)Jbus address Slave Id Default value Possible value26 250 9600 2400, 4800, 9600, 1920060 21362 CIRCUIT SELECTOR Installation & Maintenance Page 16 / 32
8.6 Ethernet link configuration:The circuit selector can be equipped with one or two Ethernet interfaces. The used protocol isMODBUS TCP (port 502).Supplied functions are : function 3 (number of words
Page 1: AUGIER SA.1 ère avenue - 2243 - BP
Page 4 and 5: 1.2 DisclaimersThis manual could co
Page 6 and 7: 5 INSTALLATION:Cubicle: It can be f
Page 8 and 9: 6.2 Remote Control ModeSwitch Sn on
Page 10: 8.1.2 Wire remote control with INTE
Page 14 and 15: 8.5 RS485/RS422 Serial Link configu
Page 18 and 19: 8.7 CS control & monitoring using s
Page 20 and 21: 9 INTERMODBUS SOFTWAREThe software
Page 22 and 23: 10 ORDERING INFORMATIONThe Circuit
Page 24 and 25: SELECTOR JBUS TABLEAdr. R/W Mode Me
Page 26 and 27: Adr. R/W Mode Memory Label Detail B
Page 28 and 29: 15 PresentationType FAA, 2 ways :Ty
Page 30 and 31: 60 21362 CIRCUIT SELECTOR Installat
Page 32: 60 21362 CIRCUIT SELECTOR Installat

Datasheet - Augier

Create successful ePaper yourself

Delete template?

Save as template?