Supplier Tooling Manual - Lockheed Martin

TMS-MC-015Revision 27Page 8 of 3621 February 20122.13.5.1 SATR’s initiated to document the condition of tool upon receipt from Buyer or a worn orunusable condition shall not affect Sellers Quality Rating.2.14 Order of Precedence2.14.1 F-16 document 16PP1957 - "Order of Precedence for Control Media for Manufacture of the F-16" takes precedence over all engineering dimensional requirements where master tools conflict withengineering requirements.2.14.2 F-22 document 5PD41327 – “Order of Precedence for Control Media for Manufacture of the F-22” provides direction for implementation and management of identified variations betweenengineering designs and F-22 Control Tooling.** 2.14.3 F-35, C-130, C-5 and P-3 program documents for “Order of Precedence for Control Media” isillustrated in PM-4053, section 3.1.2.15 Tooling Manual PM-4053* 2.15.1 Tooling Manual PM-4053 is the Buyer’s Manufacturing Specifications for Tooling. PM-4053 is“Protected Information” and access can be granted only to Sellers authorized to performmanufacturing, rework or repair of “specific” Buyer Furnished tooling on a continual basis. Sellersauthorized to perform manufacturing, rework or repair on a limited basis may not be granted access.Access can be granted as determined by Buyer’s Manufacturing Engineering organization.2.15.2 To obtain access, Seller shall make a request to Buyer. Buyer will initiate the process ofgranting access by completing an internal Form # FWP5176 that is only found on the internal Intranetsystem.** 2.15.3 Tool design and manufacturing requirements set forth in PM-4053 are fully imposed when thisManual (TMS-MC-015) is referenced in a PO.3.0 INTERCHANGEABLE- REPLACEABLE (“I/R”)* 3.1 Seller shall comply with I/R requirements imposed by this PO or IWTA and shall place all productiontools that controls an I/R feature into a periodic recall cycle as specified in this Manual.3.2 “Interchangeable Items” – Interchangeable Items are completely finished and have designed/controlledfeatures which allow them to be installed, removed, or replaced without alteration, misalignment, ordamage to installed or adjoining Items. Interchangeable Items require only attaching means (bolts, nuts,screws, pins, etc.) to install. Interchangeable Items do not require any fabrication operations such ascutting, filing, drilling, hammering or forcing at the point of installation.3.3 “Replaceable Items” – Replaceable Items are partially finished and have designed/controlled featureswhich require alteration of the Items in addition to the normal application and/or methods of attachment atthe point of installation. Such alterations are limited to specified areas and may include drilling, filing,trimming, bending, etc.3.4 “Interchangeable Category Items” – Items so designated are typically Items which are attached bybolts or screws, readily removable and replaceable. Such Items are designed in such a manner that alllike Items made within the engineering drawing tolerances will substitute one for another. InterchangeableCategory Items are Items that are maintained by Seller through use of normal manufacturing methods andcompliance with engineering drawing dimension tolerances, without the use of I/R Control Media.IMPORTANT NOTICE: A hard copy of this document may not be the document currently in effect. The current version is ALWAYSthe version on the LOCKHEED MARTIN network.