Document, IMA CLI Protocol Specification - Livewire Connections Ltd

Document, IMA CLI Protocol Specification3.1.7.3 blockage_output This set/show external modem lock input polarity for selected modem IO. Determines thepolarity (high or low) used by the external modem to indicate block state.Value: low_block, hi_block.Default: low_block.3.1.7.4 xmod_lock This set/show external modem lock state. Determines whether the system listen to the locksignal from external modem or not. For Tx/Rx system this option should be on because it is themodem that identifies the satellite. For Rx only system this option should be off since it eitheruses NID to identify the satellite (via DVB) or the signal-above-threshold.Value: on, off.Default: on.3.2 antennaStores all antenna related settings of the system.3.2.1 name This set/show antenna name. Support up to 32 characters.Default: [Enter Description]3.2.2 model This set/show antenna model. Support up to 32 characters.Default: [Enter Model]3.2.3 az_target This set/show Azimuth target, a position on azimuth axis that the antenna will target.Range: 0.0 – 359.9 (degree)Default: 0.03.2.4 el_target This set/show Elevation target, a position on elevation axis that the antenna will target. 0 is theposition when the reflector is facing horizon, parallel to the ground. 90 is the position when thereflector is perpendicular to the ground (high look).Range: 0.0 – 90.0 (degree)Default: 0.03.2.5 cl_target This set/show Cross-Level target, a position on cross-level axis that the antenna will target.Range: -30.0 – 30.0 (degree)Default: 0.03.2.6 linear_pol_target This set/show linear polarity angle target.Range: -92.0 – 182.0 (degree)Default: 0.03.2.7 circular_pol_target This set/show circular polarity angle target.Range: -92.0 – 182.0 (degree)Default: 0.03.2.8 tracking This set/show tracking mode state.Value: on, off.Default: on.3.2.9 searching This set/show searching mode state.Value: on, off.Default: off.Page 37 of 52Document No135163 Rev B