Adjunct interfaces - Avaya Support

ID Keywords Symptom To resolve this, use: Until then:020046sCallForwarding,DCS/ETN,ISDN, QSIG,DCS/ETN,Trunks,Messaging,DisplaysFor call forward scenarios involvingrerouting over QSIG, with QSIG-DCSinterworking active, the information of thecalled principal is not carried in the DCSDIST_RING message, so that the callermust re-enter the desired number inresponse to a generic greeting. The calledparty number is also blanked out for DCStrunks configured as enbloc, which mayresult in the call not getting to the correctmailbox in a voice mail system.Load 03.0.526.5 (Release 1.3)or later of AvayaCommunication ManagerTo prevent the called party numberfrom being blank, change the DigitHandling field on the trunk groupform from enbloc/enbloc toenbloc/overlap.015301sLinksCommands of the form 'list cti-link count ' do not execute properly; only ctilink"x" is listed, rather than “x” plus up to“y” links following it.Load 03.0.526.5 (Release 1.3)or later of AvayaCommunication Manager013751sISDN, QSIG,Hunt Group,QUDIX, CallCoverageA call to a hunt group having coveragepath set on a QSIG trunk to Audix doesnot arrive in the correct mailbox. May betrue on earlier releases as well.Patch 02.0.110.4-5050(requires Release 1.2 of AvayaCommunication Manager) orlaterInstead of using a hunt group toget the call into voice mail, replacethe hunt group with an extensionnumber administered withouthardware (AWOH).Wednesday, 15 October 2003 Avaya Communication Manager, Release 1.3.1Page 4 of 4Resolutions for the DEFINITY ServersAdjunct interfaces