2009 TSX Engine Block Heater - Bernardi Acura Parts & Accessories
2009 TSX Engine Block Heater - Bernardi Acura Parts & Accessories 2009 TSX Engine Block Heater - Bernardi Acura Parts & Accessories
19. Route the heater harness as shown, and secure thewire tie with clip (point D) to the vehicle frame.21. Release the engine reservoir (one hook).Use thishole.THREADEDHOLE (not used.)FRONTCOOLANTRESERVOIRRIGHTHEADLIGHTVEHICLEFRAMEFRONTHEATERHARNESSRIGHTHEADLIGHTWIRE TIEWITH CLIP(point D)FRONT20. Route the heater harness as shown, and secure it tothe bracket with two black wire ties (points E and F).22. Route the heater harness as shown, and secure it tothe vehicle harness with three black wire ties.FRONTHOOKHEADLIGHTBLACK WIRE TIEBRACKETHEATERHARNESSVEHICLEHARNESSHEATERHARNESSRIGHTHEADLIGHTBLACK WIRE TIE(point F)BLACKWIRE TIE(point E)FRONT791708BH3 BLACKWIRE TIESVEHICLECLIP791711AH6 of 8 BII 39057-39656 (0804)© 2008 American Honda Motor Co., Inc. – All Rights Reserved.
23. Route the heater harness as shown, and secure thewire tie with clip (points G) to the vehicle frame.25. Secure the heater harness to the front bumper grillewith four black wire ties.FRONTBUMPERHEATERHARNESSVEHICLEFRAME24. Bring the front bumper close to the vehicle. Routethe heater harness to the front bumper grille asshown, and install the front bumper in the originalposition.• Have an assistant help you when removing andinstalling the front bumper.• Reconnect the fog light connectors.WIRE TIE WITH CLIP(point G)791712CH• Install the clips securely so that they are notraised.BLACKWIRE TIES26. Attach the protective cap to the front bumper grille,and plug the connector of the heater harness into theprotective cap.HEATER HARNESSCONNECTORFRONTBUMPERGRILLEHEATERHARNESSPROTECTIVECAP791714AHFRONTBUMPERGRILLEFRONTBUMPERFRONTBUMPER791715BHFRONTBUMPERGRILLEHEATERHARNESS791713AH© 2008 American Honda Motor Co., Inc. – All Rights Reserved.BII 39057-39656 (0804)7 of 8
- Page 1: AccessoryApplicationPublications No
- Page 4 and 5: 11. Remove the heat shield (two bol
- Page 8: 27. Reinstall all removed parts and
23. Route the heater harness as shown, and secure thewire tie with clip (points G) to the vehicle frame.25. Secure the heater harness to the front bumper grillewith four black wire ties.FRONTBUMPERHEATERHARNESSVEHICLEFRAME24. Bring the front bumper close to the vehicle. Routethe heater harness to the front bumper grille asshown, and install the front bumper in the originalposition.• Have an assistant help you when removing andinstalling the front bumper.• Reconnect the fog light connectors.WIRE TIE WITH CLIP(point G)791712CH• Install the clips securely so that they are notraised.BLACKWIRE TIES26. Attach the protective cap to the front bumper grille,and plug the connector of the heater harness into theprotective cap.HEATER HARNESSCONNECTORFRONTBUMPERGRILLEHEATERHARNESSPROTECTIVECAP791714AHFRONTBUMPERGRILLEFRONTBUMPERFRONTBUMPER791715BHFRONTBUMPERGRILLEHEATERHARNESS791713AH© 2008 American Honda Motor Co., Inc. – All Rights Reserved.BII 39057-39656 (0804)7 of 8