Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV C (10-01-10)INSTALLATION MANUAL – D517. Connect the electrical connection box via conduit to the sensor (see Figure 59).DELETEDCable breaksensorElectricalconnectionboxFigure 59. Electrical Connection Box18. Electronically connect the transducer wiring (see Figure 60).Transducerwiring(yellow)Figure 60. Transducer Wiring19. Install electrical connections as diagrammed in Figure 21 below:Celesco EncoderCable (yellow)MicroconnectorReceptacle(on side of box)Cable BreakSensor(Gray)DELETEDRed/ Red/Green Black BlueBlack WhiteBrown BrownFigure 61. Electrical WiringAPPENDIX C – HISTORICAL CONFIGURATIONSC-3
REV C (10-01-10)INSTALLATION MANUAL – D531. Monitor the ball valve fittings for leaks during the filling process by applying soapy waterand looking for bubbles. Verify that the ball valves are open when monitoring for leaksto test the downstream fittings up to the cap.OLD DESIGNBall valveFigure 62. Counterweight Actuator Ball ValvePage A-2:Appendix A. Site Layout & <strong>Installation</strong> DrawingsFigure A-3. Pier Layout (Top View)APPENDIX C – HISTORICAL CONFIGURATIONSC-4
Page 1 and 2:
Installation Manualfor the D5 Pumpi
Page 3 and 4:
REV D (10-22-10)INSTALLATION MANUAL
Page 5 and 6:
REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 9 and 10: REV D (10-01-10)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19 and 20: REV C (10-01-10)INSTALLATION MANUAL
Page 57: REV C (10-01-10)INSTALLATION MANUAL
show all

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?