Installation Manual - Model 5 - Tundra Process Solutions Ltd.

More documents

Recommendations

Info

REV A (05-01-09)INSTALLATION MANUAL – D522. Using Figure 24 as a general guide for cable routing.Figure 24. Cable Routing Diagram23. Route the cable under the sheave of the first pulley to the underside of the sheave to theon the other sheave on the opposite side of the cylinder (see Figure 25).Figure 25. Routing Cable under SheaveSECTION 4 – UNPACKING AND PUMP UNIT PREASSEMBLY17
REV A (05-01-09)INSTALLATION MANUAL – D524. Route cable around the second pulley, and continue the process of cable routing untilboth pulleys are wired (see Figure 26).Pulley #2RoutingFigure 26. Finalized Pulley Routing25. Tie off the cables using the wedge sockets and cable clamps to secure the cable to thecable weldment (see Figure 27).WedgeSocketCableClampFigure 27. Installing Wedge Sockets and Cable Clamps26. Install leveling feet to the base of unit and apply anti-seize grease (see Figure 28).Anti-seizecompoundFigure 28. Leveling Feet on BaseSECTION 3 – TOOLS & SPECIAL EQUIPMENT18
Page 1 and 2: Installation Manualfor the D5 Pumpi
Page 3 and 4: REV D (10-22-10)INSTALLATION MANUAL
Page 7 and 8: REV A (05-01-09)INSTALLATION MANUAL
Page 15 and 16: REV (-01-)INSTALLATION MANUAL - D5
Page 19 and 20: REV C (10-01-10)INSTALLATION MANUAL
Page 21: REV C (10-01-10)INSTALLATION MANUAL
Page 59: REV C (10-01-10)INSTALLATION MANUAL

Installation Manual - Model 5 - Tundra Process Solutions Ltd.

Create successful ePaper yourself

Delete template?

Save as template?