Installation Manual - Model 5 - Tundra Process Solutions Ltd.

REV (-01-)INSTALLATION MANUAL – D5Pumping Unit Final AssemblyNOTE:Use an overhead crane (rated at 21,000 lbs) when moving the completedassembly to prevent damage to either nylon pulleys or hydraulic cylinder.Complete final assembly in accordance with the following steps:1. Install the transducer into the cylinder support using two 5/16-inch screws (see Figure 3).TransducerMountingscrews (2x)Figure 3. Installing Celesco Transducer Assembly2. While the cylinder is supended, align the cylinder assembly to the base and counterweightstructure by positioning the cylinder bolt holes with the holes in the base (see Figure 4).Base side ofcylinderBolt holes(4X)CylinderFigure 4. Aligning the Cylinder (Base side shown)3. Secure the cylinder to the base structure using four 1-1/4 x 3-inch bolts and lockwashers. Use anti-seize compound on the bolt thread (see Figure 5).Base structuresideCylinder bolts(upper)Cylinder bolts(lower)Figure 5. Securing the Cylinder (Base Side)SECTION 3 – TOOLS & SPECIAL EQUIPMENT10