13.07.2015 Views

Manual - Jøtul stoves and fireplaces

Manual - Jøtul stoves and fireplaces

Manual - Jøtul stoves and fireplaces

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

LIGHTING INSTRUCTIONSFOR YOUR SAFETY, READ BEFORE LIGHTING.138914 Rev. Q 8/28/12WARNING:IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSIONMAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.A. This appliance is equipped with an ignitiondevice which automatically lights the pilot.Do not try to light the pilot by h<strong>and</strong>.B. BEFORE LIGHTING, smell all around the appliancearea for gas. Be sure to smell next to thefloor because some gas is heavier than air <strong>and</strong>will settle to the floor.WHAT TO DO IF YOU SMELL GAS:• Extinguish any open flame.• Open windows.• Do not light any appliance.• Do not touch any electrical switches.• Do not use any phone in your building.• Immediately call your gas supplier from aneighbor’s phone.• If your gas supplier cannot be reached, call thefire department.C. Use only your h<strong>and</strong> to push in or turn thegas control knob. Never use tools. If the knobwill not push in or turn by h<strong>and</strong>, do not tryto repair it. Call a qualified technician. Forceor attempted repair may result in a fire orexplosion.D. Do not use this appliance if any part has beenunder water. Immediately call a qualified servicetechnician to inspect the appliance <strong>and</strong> toreplace any part of the control system <strong>and</strong> anygas control which has been under water.LIGHTING INSTRUCTIONS1. STOP! Read the safety information above.2. Set the thermostat to the lowest setting.3. Set the Mode Control Switch to the “OFF” position.4. This appliance is equipped with an ignition devicewhich automatically lights the pilot.Do not try to light the pilot by h<strong>and</strong>.7. Set the Mode Control Switch to the “REMOTE” position.PILOT LIGHT ASSEMBLYREMOTE RECEIVERMODE CONTROL SWITCH5. Wait five (5) minutes to clear out any gas. Then,smell for gas, including near the floor. If you smellgas, STOP! Follow “B” in the safety informationabove on this label. If you do not smell gas, go tothe next step.6. Set the Mode Control Switch to the “ON” position.The pilot will light.8. Set the thermostat to the desired setting to lightthe burner.9. If the appliance will not operate, follow the instructions”To Turn Off Gas To Appliance”, <strong>and</strong> callyour service technician or gas supplier.TO TURN OFF GAS TO THE APPLIANCE:1. Set the thermostat to the lowest setting.2. Turn off all electrical power to the appliance ifservice is to be performed.3. Set the Mode Control Switch to the “OFF” position.4. Close control access door.39

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!