Manual - JÃ¸tul stoves and fireplaces

More documents

Recommendations

Info

138914 Rev. Q 8/28/12Jøtul GF 370 DVOperationFeatures OverviewThe Proflame GTMFS system is a modular remotecontrol system that directs the functions of the JøtulGF 370 gas freestanding unit. It is configured to controlthe on/off operation both manually andthermostatically, with standard and “Smart” thermostatfeatures. It will also control flame modulation,manual flame control, fan on/off and speed andon/off of accent lighting features.The system is an IPI system (Intermittent PilotIgnition) and also has a built in switch which allowsyou to keep the pilot lit continuously if desired (CPIConstant Pilot Ignition). The power is provided to theFCM (Fan Control Module) using 120v electricity andhas a 6volt DC battery back-up for operation during apower failure.Remote Control TransmitterThis new remote system has all controls available onits face for reliable, ease of use. It gives room temperaturereadout, set temperature readout, all functionabilities as well as childproof lockout and low batteryindicator. Icons appear on the screen indicatingwhich mode of operation you are controlling. Thefour button controls are easy to learn and simple tooperate. The remote transmitter is powered by 3-1.5vAAA batteries.Remote Control ReceiverThe receiver is powered by 4-1.5v AA batteries. Thisunit has a manual on/off switch to light the burner ifthe remote should become inoperative.Fan Control ModuleThe Fan Control Module (FCM) is the electrical heartof the system. It provides power to all components,120v ac when available, and converts to 6v DCwhen it is not. This powers the receiver, making thebatteries in the receiver a backup power source, thusprolonging the life of the batteries. The FCM sendspower to the fan system and the accent light. Whenno line power is available these features will notoperate.Ignition ModuleThis is the brain of the system. It allows the pilot tobe set up as an IPI or CPI unit. It tells the burner tolight or turn off, and provides the ignitor with theelectricity needed for sparking. All functional commandsare routed through this part of the systemand distribute the signal to the appropriate component.Sit 885 Modulating ValveThis valve has the ability to be stepped down in sixincrements between high and low. It can be donemanually or by setting the remote control to theSmart thermostat modulation mode. Automaticmodulation means that as the room temperatureapproaches the limit set for shut down, the valvegradually decreases or “steps-down” the fire intensity.Conversely, as room temperature cools, the valvegradually increases flame intensity. The overall resultis more comfortable even heating, minimizing temperaturepeaks and valleys.Pilot AssemblyThe pilot contains a pilot hood, igniter, and a sensorrod. The igniter sends a spark to the pilot hood whichlights the gas. The sensor rod is then engulfed by thepilot flame, flame rectification occurs and the unitremains lit. If rectification does not occur the mainburner will not light and the pilot will shut down.WARNING:READ AND UNDERSTAND ALL OPERATINGINSTRUCTIONS BEFORE ATTEMPTING TO OPERATETHIS APPLIANCE. DO NOT ALLOW ANYONE TOOPERATE THIS APPLIANCE WHO HAS NOT READAND UNDERSTOOD THESE INSTRUCTIONS. KEEPTHE REMOTE CONTROL TRANSMITTER WHERECHILDREN CANNOT REACH IT.WARNING:SEVERE INJURY. THIS APPLIANCE CAN BE SET TOOPERATE THERMOSTATICALLY. BE AWARE THATTHE STOVE MAY BE VERY HOT EVEN WHEN THEBURNER IS NOT APPARENTLY OPERATING.KEEP CHILDREN AWAY FROM THE APPLIANCE.WARNING:OBSERVE CAUTION NEAR THE GLASS PANEL. THEGLASS MAY SHATTER IF STRUCK BY AN OBJECT.ALWAYS HANDLE THE GLASS PANEL WITH CARE.24
138914 Rev. Q 8/28/12Control FunctionsPilot ModeIn most cases you will want to operate the stove in IPImode. This allows the most efficient use of gas, burningthe pilot light only when the thermostat calls forthe burner to ignite.The CPI mode permits functional flexibility withina wide range of installation characteristics. The pilotflame remains lit when the burner is off. This is an advantagein those instances when a cold system maybedifficult to start in IPI mode. The pilot can be run untilthe system has warmed sufficiently for IPI operation.NOTE: THE IGNITOR WILL ALWAYS SPARK WHENEVERTHE PILOT MODE IS SWITCHED TO CPI, REGARDLESS OFTHE POSITION OF THE RECEIVER SWITCH.Remote ReceiverThe Remote Receiver is powered through the FanControl Module. The Receiver can be set to one of threedifferent positions. See fig. 39.ON - this is a manual override allowing the burner tofunction without remote control. The ignitor will sparkwithin 3 seconds .REMOTE - Permits full function of all components byremote control Transmitter activity.OFF - Disconnects communication between the transmitterand receiver. Turns off IPI functionality. Turn theReceiver to “OFF” whenever the stove will not be usedand whenever service is performed.Remote TransmitterThe Transmitter features a simple button layout andinformative display screen. See fig. 40. A bracket isincluded for convenient wall-mount storage.ON / OFF Key - controls Burner, Fan, and Lamp functions.THERMOSTAT Key - Used to set either Manual orThermostatic Control andindex through thermostaticfunctions.UP / DOWN Arrow Key - Selectsthermostat temperaturerange and fan speed.MODE Key - used to selectthe component to be controlled:Burner, Fan, or Lamp.DISPLAY - graphically indicatestemperature settingsand status of Thermostat,Burner, Fan, and Lamp.TransmissionThermostatON / OFF / SMARTSet PointTemperature Level StateBurnerModulationFan ModulationFigure 39. Main Control Panel.CPI (Continuous Pilot Ignition)IPI (Intermittent Pilot Ignition)Blue LCD ScreenON/OFF KeyTHERMOSTAT KeyUP/DOWN KeyMODE KeyFigure 40. Remote transmitter function keys.Figure 41. Remote transmitter display data.OFFONSMARTMAX MAX AUX°F°CAccent LampDimmer ControlReceiver in “ON”positionChild Safety Lock-outLow Battery AlarmRoomTemperatureSplit BurnerN/ALamp - ON / OFF25
Page 1 and 2: Jøtul GF 370 DVDirect Vent Gas Sto
Page 3: 138914 Rev. Q 8/28/12Table of Conte
Page 6 and 7: 138914 Rev. Q 8/28/123.0 Safety Inf
Page 8 and 9: 138914 Rev. Q 8/28/12Venting Requir
Page 10 and 11: 138914 Rev. Q 8/28/12Horizontal Ter
Page 12 and 13: 138914 Rev. Q 8/28/12Vent Restricti
Page 14 and 15: 138914 Rev. Q 8/28/12Stove Assembly
Page 16 and 17: 138914 Rev. Q 8/28/125. Fuel Conver
Page 18 and 19: 138914 Rev. Q 8/28/126. High Altitu
Page 20 and 21: 138914 Rev. Q 8/28/12Tumbled Stones
Page 22 and 23: 138914 Rev. Q 8/28/1210. Initial Sy
Page 26 and 27: 138914 Rev. Q 8/28/12Remote Transmi
Page 28 and 29: 138914 Rev. Q 8/28/12SPARKELECTRODE
Page 30 and 31: 138914 Rev. Q 8/28/12MaintenanceThi
Page 32 and 33: 138914 Rev. Q 8/28/1223 32024283431
Page 34 and 35: 138914 Rev. Q 8/28/12Figure 66. Spu
Page 36 and 37: 138914 Rev. Q 8/28/12Appendix AMobi
Page 38 and 39: 138914 Rev. Q 8/28/12Your stove has
Page 40: August, 2012138914-Q138914 Rev. Q 8

Manual - JÃ¸tul stoves and fireplaces

Create successful ePaper yourself

Delete template?

Save as template?