Manual - Jøtul stoves and fireplaces

138914 Rev. Q 8/28/12Jøtul GF 370 DVOperationFeatures OverviewThe Proflame GTMFS system is a modular remotecontrol system that directs the functions of the JøtulGF 370 gas freestanding unit. It is configured to controlthe on/off operation both manually andthermostatically, with standard and “Smart” thermostatfeatures. It will also control flame modulation,manual flame control, fan on/off and speed andon/off of accent lighting features.The system is an IPI system (Intermittent PilotIgnition) and also has a built in switch which allowsyou to keep the pilot lit continuously if desired (CPIConstant Pilot Ignition). The power is provided to theFCM (Fan Control Module) using 120v electricity andhas a 6volt DC battery back-up for operation during apower failure.Remote Control TransmitterThis new remote system has all controls available onits face for reliable, ease of use. It gives room temperaturereadout, set temperature readout, all functionabilities as well as childproof lockout and low batteryindicator. Icons appear on the screen indicatingwhich mode of operation you are controlling. Thefour button controls are easy to learn and simple tooperate. The remote transmitter is powered by 3-1.5vAAA batteries.Remote Control ReceiverThe receiver is powered by 4-1.5v AA batteries. Thisunit has a manual on/off switch to light the burner ifthe remote should become inoperative.Fan Control ModuleThe Fan Control Module (FCM) is the electrical heartof the system. It provides power to all components,120v ac when available, and converts to 6v DCwhen it is not. This powers the receiver, making thebatteries in the receiver a backup power source, thusprolonging the life of the batteries. The FCM sendspower to the fan system and the accent light. Whenno line power is available these features will notoperate.Ignition ModuleThis is the brain of the system. It allows the pilot tobe set up as an IPI or CPI unit. It tells the burner tolight or turn off, and provides the ignitor with theelectricity needed for sparking. All functional commandsare routed through this part of the systemand distribute the signal to the appropriate component.Sit 885 Modulating ValveThis valve has the ability to be stepped down in sixincrements between high and low. It can be donemanually or by setting the remote control to theSmart thermostat modulation mode. Automaticmodulation means that as the room temperatureapproaches the limit set for shut down, the valvegradually decreases or “steps-down” the fire intensity.Conversely, as room temperature cools, the valvegradually increases flame intensity. The overall resultis more comfortable even heating, minimizing temperaturepeaks and valleys.Pilot AssemblyThe pilot contains a pilot hood, igniter, and a sensorrod. The igniter sends a spark to the pilot hood whichlights the gas. The sensor rod is then engulfed by thepilot flame, flame rectification occurs and the unitremains lit. If rectification does not occur the mainburner will not light and the pilot will shut down.WARNING:READ AND UNDERSTAND ALL OPERATINGINSTRUCTIONS BEFORE ATTEMPTING TO OPERATETHIS APPLIANCE. DO NOT ALLOW ANYONE TOOPERATE THIS APPLIANCE WHO HAS NOT READAND UNDERSTOOD THESE INSTRUCTIONS. KEEPTHE REMOTE CONTROL TRANSMITTER WHERECHILDREN CANNOT REACH IT.WARNING:SEVERE INJURY. THIS APPLIANCE CAN BE SET TOOPERATE THERMOSTATICALLY. BE AWARE THATTHE STOVE MAY BE VERY HOT EVEN WHEN THEBURNER IS NOT APPARENTLY OPERATING.KEEP CHILDREN AWAY FROM THE APPLIANCE.WARNING:OBSERVE CAUTION NEAR THE GLASS PANEL. THEGLASS MAY SHATTER IF STRUCK BY AN OBJECT.ALWAYS HANDLE THE GLASS PANEL WITH CARE.24