Manual - JÃ¸tul stoves and fireplaces

More documents

Recommendations

Info

138914 Rev. Q 8/28/125. Fuel ConversionThe GF 370 DV gas stove is shipped from the factoryequipped to burn Natural gas. Propane fuel conversionkit 156800 is included with the stove to enableuse with LP gas if necessary. The kit contains all thecomponents needed to complete the task and ensuresafe operation, including labels that must be affixedto the stove.CAUTION: Before proceeding with this conversion,the gas supply must be shut off prior to disconnectingthe electrical power.This conversion kit shall be installed by a qualifiedservice agency in accordance with the manufacturer’sinstructions and all applicable codes and requirementsof the authority having jurisdiction. If the informationin these instructions is not followed exactly, a fire,explosion, or production of carbon monoxide may resultcausing property damage, personal injury or loss of life.The qualified service agency is responsible for the properinstallation of this kit. The installation is not proper andcomplete until the operation of the converted applianceis checked as specified in the manufacturer’s instructionssupplied with the kit.Cet équipement de conversion sera installé par uneagence qualifiée de service conformément aux instructionsdu fabricant et toutes exigences et codes applicablesde l’autorisés avoir la juridiction. Si l’informationdans cette Instruction n’est pas suivie exactement, unfeu, explosion ou production de protoxyde de carbonepeut résulter le dommages causer de propriété, pert oublessure personnelle de vie. L’agence qualifiée do serviceest esponsable de l’installation propre de cet équipemetn.L’installation n’est pas propre et complète jusqu’àl’operation de l’appareil converi est chéque suivant lescritères établis dans les instruction de propriétaire provisionnées avel l’équipement.Conversion Kit (LP #156800, NG #156801)Tools required:• 1/2” & 13 mm open end wrench or deep-well socket• Torx T20 or slotted screwdriver• 7/16” open end wrench• 3 mm allen wrenchConversion Kit Contents:• 1/4” nut driver• 4 mm allen wrench• 1 regulator tower labeled for the appropriate fuel• 2 regulator tower Torx screws• 1 burner injector (#38 mm for NG, #53 for LP)• 1 pilot orifice (#62 for NG, #35 for LP)• Label A - to be completed and applied to the baseof the valve compartment• Label B - apply to the rating plate in the space indicatedon the plate.• Small valve label - apply to valve body• Conversion instructionsFuel Conversion Procedure1. Turn off gas supply to the stove and disconnectfrom electrical power source.2. Remove the glass frame. See fig. 18.3. Loosen the primary air shutter wingnut and pushthe stem all the way back. Fig. 21.Figure 21.Primary AirShutterFigure 21. Air Shutter location.4. Pull the Burner Plate forward to disengage it fromthe burner orifice and lift it out of the firebox.5. Locate the main burner injector. See fig. 23 onpage 17. Slide the Air Shutter out of the way anduse a 1/2” open end wrench or deep-well socket toremove the burner orifice from the brass orificeholder. Replace with the orifice supplied in thekit. Tighten securely.6. Change the Air Shutter position: Lift the shuttertube up in its hinge pin slots and turn the tubeover, so that the appropriate fuel type indicator(LP or NG) is oriented facing you. See fig. 22. Pushthe shutter all the way back over the injector.7. Change the Pilot Orifice. Pull the Pilot Hood off ofits base. It will snap by the retainer clip shown inFig. 23.NGLPFigure 22. Primary air shutter orientation must bechanged for fuel type.16
138914 Rev. Q 8/28/12Pilot HeadIgnitorFlame SensorPilot OrificePrimary AirShutterRetainer ClipInjectorRegulatorDiaphragmTab & ReceptacleTerminalsFigure 23. Fuel conversion components and assembliesUsing a 4 mm allen wrench, unscrew the pilotorifice. Replace it with the orifice from the kit.Be sure the new orifice is tightly secured to preventby-pass leakage.Replace the pilot hood by simply pushing itback into place on its base.8. Reinstall the Burner Plate by engaging the venturitube with the Air Shutter. BE CERTAIN THEBURNER IS LEVEL AND SECURELY SEATED ON THESUPPORT LEGS ON THE FIREBOX FLOOR.9. Replace the variable regulator. Using a Torx T-20screwdriver, remove the two specialty screwsfrom the regulator tower on the front of thevalve. Note: To help identify which screws to remove,refer to the new regulator in the kit. See fig. 23.10. Disconnect the Regulator wire lead from thereceptacle housing terminal. Remove the regulatortower and the rubber diaphragm.Apply Label“A” HereRegulatorTowerUse new Torxscrews supplied11. Install the new variable regulator tower from thekit. Be sure that the gasket is properly positionedand tighten screws securely. Connect the wire lead.12 . Apply the identification labels to the stove so that they canbe seen by any person that may be servicing the stove.• Label “A”: Apply to front lip of the valve compartment.• Label “B”: Apply to the Rating Plate.• Small valve sticker: Apply to valve.13. Install the accessory panels and burner media asappropriate. See pages 19-21.14. Apply anti-seize lubricant to the socket head glassframe screws before reinstalling the glass frame.15. Apply gas to the system and check for leaks usinga soapy water solution or gas sensor.16. Follow the System Check instructions on pages 22-23for initial start-up and flame picture adjustment.17
Page 1 and 2: Jøtul GF 370 DVDirect Vent Gas Sto
Page 3: 138914 Rev. Q 8/28/12Table of Conte
Page 6 and 7: 138914 Rev. Q 8/28/123.0 Safety Inf
Page 8 and 9: 138914 Rev. Q 8/28/12Venting Requir
Page 10 and 11: 138914 Rev. Q 8/28/12Horizontal Ter
Page 12 and 13: 138914 Rev. Q 8/28/12Vent Restricti
Page 14 and 15: 138914 Rev. Q 8/28/12Stove Assembly
Page 18 and 19: 138914 Rev. Q 8/28/126. High Altitu
Page 20 and 21: 138914 Rev. Q 8/28/12Tumbled Stones
Page 22 and 23: 138914 Rev. Q 8/28/1210. Initial Sy
Page 24 and 25: 138914 Rev. Q 8/28/12Jøtul GF 370
Page 26 and 27: 138914 Rev. Q 8/28/12Remote Transmi
Page 28 and 29: 138914 Rev. Q 8/28/12SPARKELECTRODE
Page 30 and 31: 138914 Rev. Q 8/28/12MaintenanceThi
Page 32 and 33: 138914 Rev. Q 8/28/1223 32024283431
Page 34 and 35: 138914 Rev. Q 8/28/12Figure 66. Spu
Page 36 and 37: 138914 Rev. Q 8/28/12Appendix AMobi
Page 38 and 39: 138914 Rev. Q 8/28/12Your stove has
Page 40: August, 2012138914-Q138914 Rev. Q 8

Manual - JÃ¸tul stoves and fireplaces

Create successful ePaper yourself

Delete template?

Save as template?