Manual - JÃ¸tul stoves and fireplaces

More documents

Recommendations

Info

138914 Rev. Q 8/28/12Horizontal Termination• Minimum vertical rise from the vent collar is a 24”section vent pipe. See fig. 9. Minimum horizontalrun is 12” with natural gas and 18” with propane.• A maximum of two 90° or four 45° elbows maybe used in a horizontal termination. Wheneverpossible, use 45° elbows instead a 90° elbow asthey offer less restriction to the flow of flue gasesand intake air. Reduce the overall horizontal runby 4 feet for each 90° elbow, and 2 feet for each 45°elbow.• Snorkel Termination - ( 14” or 36”):NATURAL GAS ONLY. DO NOT USE SNORKELTERMINATION WITH PROPANE FUEL.A horizontal vent run may be made with a 90°elbow directly to the rear of the stove only whenterminated by a 14 or 36 inch snorkel cap. Fig. 10shows the minimum vent pipe requirements.14” Snorkel: The maximum horizontal vent runmust not exceed a 24” section of pipe and must bea minimum of 12”.36” Snorkel: The maximum horizontal vent runmust not exceed 5 feet and must be a minimumof 12”.• The termination cap must not be recessed intothe wall or siding. Do not fill air space in wall aroundtermination cap with any type of insulation.• Wall Cut-out: A minimum 10” X 10” square holeis adequate for proper pipe clearance through awall, provided the vent is positioned to maintain2” minimum clearance at the top. A 1” minimumclearance must be maintained to combustiblematerial around the other sides. See fig. 11.• Any horizontal run of vent must have a 1/4” rise forevery foot of run toward the termination cap.• All horizontal terminations must comply with theclearance specifications to adjacent structures asindicated in fig. 12.• Installation of a Vinyl Siding Standoff is requiredto prevent damage to vinyl siding between thevent cap and the exterior wall.• A horizontal termination cap must maintain a 3”clearance to any overhead combustible projections thatare 2 1/2” or less. It must also maintain a 12” clearancefrom projections that exceed 2 1/2”. See fig. 13.Vinyl siding projections require a default clearance of18” to the vent terminal.Figure 9. Minimum ventpipe sections required forhorizontal termination:A = 12” with NG18” with LP74 1/2”52”24”Figure 10. Minimum ventpipe sections required for a 14”Snorkel termination - NaturalGas ONLY..NGONLYA12”Minimum Vent into14” Snorkel TerminationFigure 11. Install alisted wall thimbleaccording to manufacturer’sinstructionsto maintain requiredclearance to combustiblematerials.XListed WallThimble14”Listed WallThimbley10
24”74 1/2”A138914 Rev. Q 8/28/12Figure 12. Horizontal termination clearancesNVVent Terminal X Air Supply Terminals Prohibited in this AreaA = Clearance above grade, veranda, porch , deck, or balcony: 12 inches (30 cm) minimum.B = Clearance to window or door that may be opened:**Min. 9 inches, U.S. / *12 inches (30 cm) CAN.We recommend 12 in. minimum to prevent condensationon the window.C = Clearance to permanently closed window:**Min. 9 inches, U.S. / *12 inches (30 cm) CANWe recommend 12 in. minimum to prevent condensationon the window.D = Vertical clearance to ventilated soffit located above theterminal within a horizontal distance of 2 feet (60 cm)from the center line of the terminal: 18 inches(46 cm) minimum.E = Clearance to unventilated soffit: 12 inches (30 cm)minimum.F = Clearance to outside corner: **Min. 9 inches, U.S. / *12inches (30 cm) CAN. We strongly recommend 12 inches,particularly where windy conditions prevail.G = Clearance to inside corner: ** Min. 6 inches, U.S. / *12inches (30 cm) CAN. We strongly recommend 12 inches,particularly where windy conditions prevail.12 ”305mm3”76 mm2 1/2”64 mmH = *Not to be installed within 15 feet (4.5 m) above a meter/regulatorassembly within 3 feet (90 cm) horizontallyfrom the center line of the regulator.I = Clearance to service regulator vent outlet:3 feet (91 cm) minimum.J = Clearance to non-mechanical air supply inlet to buildingor the combustion air inlet to any other appliance:12 inches (30 cm) minimum.K = Clearance to a mechanical air supply inlet:**Min. 3 feet (91 cm) above if within 10 feet horizontally,U.S. / *6 feet (1.83 m) minimum / CANL = 1 Clearance above paved sidewalk or a paved drivewaylocated on public property: 7 feet (2.1 m) min.M = Clearance under veranda, porch, deck, or balcony:12 inches (30 cm) minimum. 2N = Clearance to propane tank relief valve and filler connection***:5 feet (1.52 m) minimum to tanks not filled on site10 feet (3.05 m) minimum to tanks filled on site frombulk truck* In accordance with CSA B149 Installation Codes.** In accordance with the current ANSI Z223.1/NFPA 54, NationalFuel Gas Code. Note: Local Codes and Regulations may requiredifferent clearances.1A vent shall not terminate directly above a sidewalk or drivewaywhich is located between two single family dwellings and servesboth dwellings.2Only permitted if veranda, porch, deck, or balcony, is fully openon a minimum of two sides beneath the floor.*Figure 13.Termination clearance to overhangs.11
Page 1 and 2: Jøtul GF 370 DVDirect Vent Gas Sto
Page 3: 138914 Rev. Q 8/28/12Table of Conte
Page 6 and 7: 138914 Rev. Q 8/28/123.0 Safety Inf
Page 8 and 9: 138914 Rev. Q 8/28/12Venting Requir
Page 12 and 13: 138914 Rev. Q 8/28/12Vent Restricti
Page 14 and 15: 138914 Rev. Q 8/28/12Stove Assembly
Page 16 and 17: 138914 Rev. Q 8/28/125. Fuel Conver
Page 18 and 19: 138914 Rev. Q 8/28/126. High Altitu
Page 20 and 21: 138914 Rev. Q 8/28/12Tumbled Stones
Page 22 and 23: 138914 Rev. Q 8/28/1210. Initial Sy
Page 24 and 25: 138914 Rev. Q 8/28/12Jøtul GF 370
Page 26 and 27: 138914 Rev. Q 8/28/12Remote Transmi
Page 28 and 29: 138914 Rev. Q 8/28/12SPARKELECTRODE
Page 30 and 31: 138914 Rev. Q 8/28/12MaintenanceThi
Page 32 and 33: 138914 Rev. Q 8/28/1223 32024283431
Page 34 and 35: 138914 Rev. Q 8/28/12Figure 66. Spu
Page 36 and 37: 138914 Rev. Q 8/28/12Appendix AMobi
Page 38 and 39: 138914 Rev. Q 8/28/12Your stove has
Page 40: August, 2012138914-Q138914 Rev. Q 8

Manual - JÃ¸tul stoves and fireplaces

Create successful ePaper yourself

Delete template?

Save as template?