HX8347 - Adafruit

HX8347-G(T)240RGB x 320 dot, 262K color, TFT Mobile Single Chip Driver6.35 TE control register (PAGE0 -60h, 84h~85h)DATA SHEET Preliminary V01R/WWDNC1RB7RB6 RB5 RB4 RB3 RB2 RB1 RB0* * *TEMODE TEON * * *R 1 0 0 0TEMODE TEON 0 0 0Figure 6.88: TE control register (PAGE0 -60h)R/WWDNC1RB7TSEL15RB6 RB5 RB4 RB3 RB2 RB1 RB0TSEL14TSEL13TSEL12TSEL11TSEL10TSEL9TSEL8R 1TSEL15TSEL14TSEL13TSEL12TSEL11TSEL10TSEL9Figure 6.89: TE output line2 register (PAGE0 -84h)TSEL8R/WWDNC1RB7TSEL7RB6 RB5 RB4 RB3 RB2 RB1 RB0TSEL6TSEL5TSEL4TSEL3TSEL2TSEL1TSEL0R 1TSEL7TSEL6TSEL5TSEL4TSEL3TSEL2TSEL1Figure 6.90: TE output line1 register (PAGE0 -85h)TEMODE: Specify the Tearing-Effect mode.When TEMODE = ‘0’: The Tearing Effect Output line (TE) consists of V-Blankinginformation only.TSEL0When TEMODE =’1’: The Tearing Effect Output Line (TE) consists of both V-Blankingand H-Blanking informationNote: During Stand by Mode with Tearing Effect Line On, Tearing Effect Output pin active lowTEON: This command is used to turn ON the Tearing Effect output signal from the TEsignal line.TSEL[15:0]: This command is used to setting TE delay line at TEMODE=”0”. WhenTSEL[15:0]=16’h0000, TE output is the same as TEMODE=”0”. WhenDecimal(TSEL[15:0])=n, TE output at n-th line starting.TSEL=0n-th linen-th lineTSEL=nHimax ConfidentialFor Go-tek OnlyThis information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax.-P.161-October, 2009