HX8347 - Adafruit

HX8347-G(T)240RGB x 320 dot, 262K color, TFT Mobile Single Chip DriverDATA SHEET Preliminary V01SCROLL : This bit turns on scroll mode by setting SCROLL = ‘1’. The scroll modewindow is described by the Vertical Scroll Area command TFA[15:0], VSA[15:0],BFA[15:0] and the Vertical start address VSP[15:0] (R0Eh~R15h). To leave scrollmode to normal mode, the SCROLL bit should be set to ‘0’.INVON: This bit is display inversion mode enable bit. INVON = ‘1’, chip will be intodisplay inversion mode, and makes no change of contents of frame memory. Every bitis inverted from the frame memory to the display.(Example)memorydisplayPTLON: This command is used for turning on/off Partial mode by setting PTLON=1/0.The Partial mode window is described by the Partial Area command PSL[15:0],PEL[15:0] bits(R0Ah~R0Dh). To leave Partial mode to normal mode, the PLTON bitshould be set to ‘0’.6.5 Column address start register (PAGE0 -02~03h)R/WDNCRB7RB6 RB5 RB4 RB3 RB2 RB1 RB0W1SC15SC14SC13SC12SC11SC10SC9SC8R 1SC15SC14SC13SC12SC11SC10SC9SC8Figure 6.4: Column address start register upper byte (PAGE0 -02h)R/WDNCRB7RB6 RB5 RB4 RB3 RB2 RB1 RB0W1SC7 SC6 SC5 SC4 SC3 SC2 SC1 SC0R 1 SC7 SC6 SC5 SC4 SC3 SC2 SC1 SC0Figure 6.5: Column address start register low byte (PAGE0 -03h)Himax ConfidentialFor Go-tek OnlyThis information contained herein is the exclusive property of Himax and shall not be distributed, reproduced, or disclosedin whole or in part without prior written permission of Himax.-P.124-October, 2009