Administration of the Avaya G350 Media Gateway - Avaya Support

Initial WAN configurationConfiguring frame relayTo configure frame relay encapsulation on a WAN port:1. Ensure that the port is configured on the media module:- For an E1/T1 port, see Configuring the Avaya MM340 E1/T1 WAN media module onpage 85.- For a USP port, see Configuring the Avaya MM342 USP WAN media module onpage 88.2. Ensure that you are in the context of a serial interface that is defined on the port. If you arenot in the context of a serial interface, use the interface Serial command. To view allserial interfaces that are defined, use the show interfaces Serial command.3. Use the encapsulation frame-relay command to change the encapsulation toframe relay.4. If needed, use the frame-relay lmi commands to change the Local ManagementInterface (LMI) parameters from their default values, or use the frame-relaytraffic-shaping command to activate traffic shaping on the frame relay interface. Formore information on traffic shaping, see Traffic Shaping and Marking on page 104.5. If you want to change the queuing mode of the interface, see Configuring Weighted FairVoIP Queuing (WFVQ) on page 76 for instructions.6. Type exit to return to general context. The prompt returns to:G350-001(super)#7. Use the interface Serial if.fr-sub-if point-to-point command to create aframe relay sub-interface and enter the context of the interface. For example:- interface Serial 4/1:2.1 point-to-pointcreates frame relay sub-interface number 1 on the E1/T1 media module in slot number 4,on port number 1, with channel group number 2- interface Serial 5/1:2.3.2 point-to-pointcreates frame relay sub-interface number 3 on the E1/T1 media module in slot number 5,on port number 1, with channel group number 2, and with IP interface number 2- interface Serial 4/1.2 point-to-pointcreates frame relay sub-interface number 2 on the USP media module in slot number 4,on port number 1- interface Serial 5/1.2.1 point-to-pointcreates frame relay sub-interface number 2 on the USP media module in slot number 5,on port number 1, with IP interface number 1Note:Note:Currently only point-to-point frame relay sub-interfaces are supported.Issue 3 January 2005 95