Administration of the Avaya G350 Media Gateway - Avaya Support

Initial WAN configuration2. Use the following commands to change the idle characters, transmitter delay, encodingtype, bandwidth parameters, line monitoring, and from their default settings:- idle characters {flags|marks} sets the bit pattern used to indicate an idle line.Use the no form of this command to restore the default value (flags).- transmitter-delay {number} sets the minimum number of flags to be sent betweensuccessive packets. Use the no form of the command to restore the transmitter-delayvalue to the default (0).Note:Note:Note:The transmitter-delay command is usually used when the DCE equipmentthat is connected directly to the G350, or the router on the WAN have a receivebuffer that is not large enough to hold the traffic sent by the G350. In this case,configure transmitter-delay on the DCE equipment or the remote router inorder to preserve the high performance that you had whentransmitter-delay was configured to 0 on the G350.- nrzi-encoding enables the non-return-to-zero inverted (NRZI) line coding format onthe specified interface. Use the no form of the command to disable NRZI encoding.- bandwidth {kbps} sets the bandwidth parameter manually for the interface. Use theno form of this command to restore the bandwidth parameter to its default value (2,048).The manually specified bandwidth value overrides the dynamically calculated bandwidthduring route cost calculations.Note:If you are using the USP port as a clock source, configure the port’s bandwidth tomatch the DCE clock rate.- ignore dcd specifies how the system monitors the line to determine if it is up or down.Specify ignore dcd to ignore DCD signals, and instead use DSR/CTS signals todetermine the line’s status. Use the no form of the command to specify that DCD signalsare used to determine line status.- invert txclock inverts the transmit clock signal from the data communicationsequipment (DCE). Use the no form of the command to restore the signal to not inverted.3. Configure the interface encapsulation:- For PPP encapsulation, see Configuring PPP on page 90.- For frame relay encapsulation, see Configuring frame relay on page 95.4. Type exit to return to general context. The prompt returns to:G350-001(super)#5. Repeat Step 1 to configure additional serial interfaces on the USP port.6. Test the WAN configuration. See Verifying the WAN configuration and testingconnectivity on page 96.7. Use the copy running-config startup-config command to save the configuration.Issue 3 January 2005 89