Administration of the Avaya G350 Media Gateway - Avaya Support

Configuring a WAN InterfaceE1/T1 default settingsTable 6: E1/T1 default settings on page 88 shows the default settings for E1/T1 WAN lines onthe G350:Table 6: E1/T1 default settingsFunctionDS modeE1 framingT1 framingE1 linecodeT1 linecodeClock sourceT1 cable lengthSpeedDefault settingT1CRC4SFHDB3AMILineLong, Gain 26.0 dbE1: 64kbpsT1: 56kbpsConfiguring the Avaya MM342 USP WAN media moduleFor a list of the USP default settings, see USP default settings on page 90.To configure USP ports:1. Use the interface Serial command to enter the context of the interface. Specify theslot number of the media module, the port number, and optionally the IP interface number. Ifyou do not specify an IP interface number for the first serial interface that you define on aport, the G350 automatically assigns IP interface number 0. For each additional serialinterface that you define on the port, use a different IP interface number. For example:- interface Serial 4/1 enters a serial interface on the media module in slot number4, on port number 1.- interface Serial 5/1.2 enters a serial interface on the media module in slotnumber 5, on port number 1, with IP interface number 2.The prompt changes to:G350-001(super-if:Serial s/p)#For example:G350-001(super-if:Serial 4/1)#88 Administration of the Avaya G350 Media Gateway