Administration of the Avaya G350 Media Gateway - Avaya Support

Initial WAN configuration7. Use the interface Serial command to enter the context of the interface. Specify theslot number of the media module, the port number, the channel group number, andoptionally, the IP interface number. If you do not specify an IP interface number for the firstserial interface that you define on a channel group, the G350 automatically assigns IPinterface number 0. For each additional serial interface that you define on the channelgroup, use a different IP interface number. For example:- interface Serial 4/1:1 enters a serial interface on the media module in slotnumber 4, on port number 1, with channel group number 1.- interface Serial 5/1:2.3 enters a serial interface on the media module in slotnumber 5, on port number 1, with channel group number 2, and with IP interface number3.Note:Note:If you use the framing unframed command in Step 3 for an E1 port, a channelgroup is automatically created on the entire E1 bandwidth. The channel grouphas the number 0. In Step 6, use the command interface Serial s/p:0where s is the slot number and p is the port number.Note:Note:After the serial interface is created, its default encapsulation is PPP.8. Configure the interface encapsulation:- By default, the serial interface uses PPP encapsulation. For information on setting PPPparameters, or instructions on returning the interface to the default PPP encapsulationafter it has been configured for a different encapsulation, see Configuring PPP onpage 90.- For frame relay encapsulation, see Configuring frame relay on page 95.9. Use the ip address command to configure the IP address and subnet mask of theinterface.10. Type exit to return to general context. The prompt returns to:G350-001(super)#11. If needed, repeat Step 7 through Step 9 to configure additional IP interfaces on the samechannel group.12. If needed, repeat Step 5 through Step 9 to configure additional channel groups on the sameE1 or T1 port.13. Test the WAN configuration. See Verifying the WAN configuration and testingconnectivity on page 96.14. Use the copy running-config startup-config command to save the configuration.Issue 3 January 2005 87