Administration of the Avaya G350 Media Gateway - Avaya Support

Configuring a WAN Interface3. Use the controller command to enter controller context forthe port to be configured. The prompt changes to:G350-001(super-if:Serial s/p)#where s is the slot number of the media module, and p is the port number.4. Use the following commands to change the clock source, frame type, linecode, or cablelength parameters from the default settings:- For T1 mode:clock source {line|internal} (default is line)framing {sf|esf} (default is sf)linecode {ami|b8zs} (default is ami)cablelength {long|short} (default is long, gain26, 0db)Note:Note:Use the cablelength command to configure the cable’s transmit and receivelevels. If the cable is longer than 655 feet, use the command cablelengthlong {gain26 | gain36} {-15db | -22.5db | -7.5db | 0db}(default gain26, 0db). If the cable is 655 feet or less, use the commandcablelength short {133ft | 266ft | 399ft | 533ft | 655ft}(default 133ft). When using the cablelength short form of the command, thetransmit attenuation is configured using the loop length.- For E1 mode:clock source {line|internal} (default is line)framing {crc4|no-crc4|unframed} (default is crc4)linecode {ami|hdb3} (default is hdb3)5. Use the channel-group command to specify the channel group and time slots to bemapped, as well as the DS0 speed. For example:- For T1 mode:channel-group 1 timeslots 1,3-5,7 speed 64configures time slots numbered 1, 3-5 and 7 to be mapped in channel-group number 1,and sets the DS0 speed to 64 kbps. The default DS0 speed for T1 mode is 56.- For E1 mode:channel-group 1 timeslots 1,3-5,7 speed 64configures time slots numbered 1, 3-5, and 7 to be mapped in channel-group number 1,and sets the DS0 speed to 64 kbps. The default DS0 speed for E1 mode is 64.6. Type exit to return to general context. The prompt returns to:G350-001(super)#86 Administration of the Avaya G350 Media Gateway