Administration of the Avaya G350 Media Gateway - Avaya Support

Configuring Ethernet portsWAN Ethernet port traffic shapingYou can use traffic shaping to determine the data transfer rate on the WAN Ethernet port. To settraffic shaping, use the traffic-shape rate command in the interface context. Trafficshaping works in tandem with the configured bandwidth. If you change the traffic shape rate,this automatically changes the bandwidth. Similarly, if you change the bandwidth, thisautomatically changes the traffic shape rate.Note:Note: The traffic shape rate is determined in bits. The bandwidth is determined inkilobytes.To disable traffic shaping, use the no form of the traffic-shape rate command.For information on traffic shaping in general, see Configuring QoS parameters on page 74.Backup interfacesYou can configure backup relations between a pair of any Layer 2 serial interfaces, including theFast Ethernet interface. For instructions on how to configure backup interfaces, see Backupinterfaces on page 97.WAN Ethernet port commandsUse the following commands in FastEthernet 10/2 context for basic Ethernet configuration ofthe WAN Ethernet port:●●●●Use the autoneg command to set the port speed and duplex to auto-negotiation mode forthe external FastEthernet port. Use the no form of this command to disable theauto-negotiation mode.Use the duplex command to control the duplex setting for the interface.Use the shutdown command to set the administrative status of the current interface todown. Use the no form of this command to restore the administrative status of theinterface to up.Use the speed command to set the port speed.64 Administration of the Avaya G350 Media Gateway