Administration of the Avaya G350 Media Gateway - Avaya Support

Basic device configurationSetting reset timesIf the connection between the G350 and its registered MGC is lost, the G350 attempts torecover the connection. Use the set reset-times primary-search command and theset reset-times total-search command to set the time-out for the G350’s search forthe primary MGC and the other MGC’s on its MGC list, respectively. Use the setreset-times transition-point command to configure the point at which the primaryMGCs in the list end and the LSPs begin. For example, if there are three IP addresses in theMGC list and the third address is the LSP, the transition point should be 2.The default time for the primary search is 1 minute. The default time for the total search is 30minutes. The default transition point is 1.For example:G350-001> set reset-times primary-search 20G350-001> set reset-times total-search 40350-001> set reset-times transition-point 1In this example, in the event of a loss of connection with the registered MGC, the G350searches for the primary MGC on its MGC list for 20 minutes. If the G350 does not establish aconnection with the primary MGC within this time, it searches for the other MGCs on the list fora total of 40 minutes.Use the show recovery command to show the status of MGC and ICC monitoring andrecovery setup.Accessing the registered MGCTo access the G350’s registered MGC through the G350:●●If the MGC is an S8300 media server, use the session mgc commandIf the MGC is an S8500 or S8700 media server, use the set mediaserver command tomanually define the MGC’s IP address, then use the session mgc command to accessthe MGCIf the G350 includes an S8300, use the session icc command to access the S8300. Youcan use this command whether or not the local S8300 is the G350’s registered MGC.Note:Note:Both the session mgc command and the session icc command open atelnet connection to the MGC.To open a connection directly to the Avaya Communication Manager System Access Terminal(SAT) application in the MGC, add sat to the command. For example:G350-001> session mgc sat54 Administration of the Avaya G350 Media Gateway