Administration of the Avaya G350 Media Gateway - Avaya Support

Defining the default gatewayIf you use this command after you reset the G350, both the Active and the Configured PMIshould be the same IP address.Use the following commands to configure other identification information:● Use the set system contact command to set the contact information for the G350.● Use the set system location command to set the location information for the G350.● Use the set system name command to specify the name of the G350.Defining the default gatewayThe G350 uses a default gateway to connect to outside networks that are not listed on theG350’s routing table. To define a default gateway, use the ip default-gateway command,followed by either the IP address or name (type and number) of the interface you want to defineas the default gateway.The following example defines the interface with the IP address 132.55.4.45 as the defaultgateway:ip default-gateway 132.55.4.45The following example defines Serial interface 5/1:1 as the default gateway:ip default-gateway Serial 5/1:1Configuring the Media Gateway Controller (MGC)This section provides information about configuring a Media Gateway Controller (MGC) to workwith the G350 and includes the following topics:●●●●●The Media Gateway Controller (MGC) — an overview of the types of MGCs that can beused with the G350Configuring the MGC list — instructions on how to register primary and backup MGCs forthe G350Setting reset times — instructions on how to set time-outs for when the G350 has toreestablish a connection with its MGCAccessing the registered MGC — instructions on how to access the registered MGC usingthe CLIMonitoring the ICC or LSP — instructions on how to monitor the connection between theG350 and its registered MGC using the CLIIssue 3 January 2005 51