Administration of the Avaya G350 Media Gateway - Avaya Support

Attaching policy lists to an interfaceYou can configure which policy lists are attached to each interface. You can choose the IngressAccess Control List and the Egress Access Control List from among the access control lists thatare configured on the G350. You can choose the Ingress QoS List and the Egress QoS Listfrom among the QoS lists that are configured on the G350.To attach an access control list to an interface as its Ingress Access Control List, enter theinterface context and type ip access-group list number in. To attach an access controllist to an interface as its Egress Access Control List, enter the interface context and type ipaccess-group list number out.To attach a QoS list to an interface as its Ingress QoS List, enter the interface context and typeip qos-group in. To attach an access control list to an interface as itsEgress QoS List, enter the interface context and type ip qos-group out.For example, the following sequence of commands attach policy lists to the VLAN 2 interface.Access control list 301 becomes the Ingress Access Control List for VLAN 2. QoS list 401becomes the Egress QoS List for VLAN 2.G350-001# interface Vlan 2G350-001(if:Vlan 2)# ip access-group 301 inDone!G350-001(if:Vlan 2)# ip qos-group 401 outDone!To remove a list from an interface, use the no form of the appropriate command. For example, ifthe Ingress Access Control List for the VLAN 1 interface is list number 302, you can remove thelist from the interface by typing the following commands:G350-001(super)# interface Vlan 1G350-001(super-if:Vlan 1)# no ip access-group inDone!Note:Note:You cannot change or delete a default list. You cannot change or delete any listwhen it is attached to an interface. In order to change or delete a list that isattached to an interface, you must first remove the list from the interface. You canthen change or delete the list. After changing the list, you can reattach the list tothe interface.Issue 3 January 2005 259