Administration of the Avaya G350 Media Gateway - Avaya Support

Configuring spanning tree●●●Use the set spantree tx-hold-count command to set the value in packets used bythe spanning tree in order to limit the maximum number of BPDUs transmitted during ahello-time period.Use the set spantree version command to set the version of the spanning treeprotocol.Use the show spantree command to display spanning-tree information.Spanning tree configuration examplesThis section provides spanning tree configuration examples.The following example enables spanning tree on a port:G350-003(super)# set port spantree enable 6/8port 6/8 was enabled on spantreeThe following example disables spanning tree on a port:G350-003(super)# set port spantree disable 6/8port 6/8 was disabled on spantreeThe following example configures the version of the spanning tree default path cost used by thisbridge:G350-003(super)# set spantree default-path-cost common-spanning-treeSpanning tree default path costs is set to common spanning tree.The following example configures the time used when transferring the port to the forwardingstate:G350-003(super)# set spantree forward-delay 16bridge forward delay is set to 16.The following example configures the time interval between the generation of configurationBPDUs by the root:G350-003(super)# set spantree hello-time 2bridge hello time is set to 2.The following example configures the amount of time an information message is kept beforebeing discarded:G350-003(super)# set spantree max-age 21bridge max age is set to 21.The following example configures the bridge priority for spanning tree:G350-003(super)# set spantree priority 36864Bridge priority set to 36864.Issue 3 January 2005 147