Administration of the Avaya G350 Media Gateway - Avaya Support

Configuring PoEPoE configuration CLI commandsUse the following commands to configure PoE on an Avaya G350 MM314 PoE media module:●●●●●Use the set port powerinline command to enable or disable load detection on aport.Use the set port powerinline type command to configure the connected PD type.Use the set port powerinline priority to configure the PoE priority level over aport.Use the set powerinline trap enable to configure PoE traps and the consumptionusage threshold value.Use the show powerinline command to display Power over Ethernet (PoE)information.Note:Note:If another PoE-enabled device (such as a P333T-PWR switch) is connected to aport, the show powerinline command may incorrectly show the port powerstatus as Delivering Power. To disable inline power for a port connected to aP333T-PWR, use the command set port powerinline disable.PoE configuration examplesThis section provides PoE configuration examples.The following example enables PoE on a port:G350-003(super)# set port powerinline 6/12 enableLoad detection process on port 6/12 is enabled.The following example disables PoE on a port:G350-003(super)# set port powerinline 6/12 disableLoad detection process on port 6/12 is disabled.The following example configures PoE priority on a port:G350-003(super)# set port powerinline priority 6/14 highPowering priority on port 6/14 was set to High.The following example displays PoE information:G350-003(super)# show powerinlineActual powerinline power consumption is 4 W.Powerinline power consumption trap threshold is 207(99%) Watts.114 Administration of the Avaya G350 Media Gateway