warning - Graco Inc.

ServiceNOTE: Refer to Fig. 10 for steps 17 to 21.17. Install the rubber pad (28) and washer (27) in thebottom of the detent housing (45). Grease theplunger (46), assemble the axles (52) and rollers(4) and grease them, and install these parts in thedetent housing.Model 208356 Shown10318. Position the detent housing (45) on the manifolds(41), and install the washers (7) and screws (13).Tighten securely.5119. Grease the guides (33) and install with the springs(34) into each side of the detent housing (45).Screw the retainers (32) into both sides of thehousing; they should readily screw all the way intothe housing by hand. If they do not, the detentsare not assembled correctly; inspect, and correctany misalignment. Now firmly tighten the retainers(32).137WARNINGMOVING PARTS HAZARDDo not operate without the air motorshield in place. Pinching or amputationof fingers or hands may occur. SeeMOVING PARTS HAZARD on page 3.20. Install the grommet (40), air motor shield (51), andthe air inlet fitting (3). Install the screws (10).Reconnect the ground wire.452827414152461133140343221. Before connecting the displacement pump, connectan air hose to the motor and run it slowly tocheck for smooth operation.411 GreaseFig. 100726818 307049