Operating Instructions - Snap-on Equipment
Operating Instructions - Snap-on Equipment
Operating Instructions - Snap-on Equipment
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PC MaintenanceThe Setup window c<strong>on</strong>tains four tabs:• Hardware C<strong>on</strong>figurati<strong>on</strong>• Calibrati<strong>on</strong>• TSI• MiscellaneousHardware C<strong>on</strong>figurati<strong>on</strong> SetupThe Hardware C<strong>on</strong>figurati<strong>on</strong> tab allows you to specify details about the benchmodule, gas communicati<strong>on</strong>s port and RPM items.Figure 3G-13: Hardware C<strong>on</strong>figurati<strong>on</strong> Setup ScreenBench Module: In the future, FGA may provide a choice of several gasbench modules. Select the appropriate gas bench module and set the gascommunicati<strong>on</strong>s port appropriately. FGA is equipped with the following gasbench modules:— <str<strong>on</strong>g>Snap</str<strong>on</strong>g>-<strong>on</strong> FGA-5Gas Com Port: Default is 1. You can use other ports.RPM Module: FGA is equipped with <strong>on</strong>ly <strong>on</strong>e RPM module, <str<strong>on</strong>g>Snap</str<strong>on</strong>g>-<strong>on</strong> FGARPM.RPM Enabled: If the opti<strong>on</strong>al RPM Kit is installed, check (✓) this box.✓ If you change the gas bench module or gas communicati<strong>on</strong>s port,FGA verifies that communicati<strong>on</strong> to the device is working properlywhen you select the OK butt<strong>on</strong>.3G-9
Change language