How to use non-linear correction under WsxM

More documents

Recommendations

Info

NANOTEC TECHNICAL NOTE 6 V1.0 4Figure 17. You may need to adjust the height and min size if needed, inorder to obtain one green cross for each real hole in yourgrid. Look at Figure 2 to see the example.Figure 2
NANOTEC TECHNICAL NOTE 6 V1.0 58. When done, click on create center map. A new window willopen. Now you can close the dialog box and save the centermap image.9. Repeat the process with the second image.Adjusting the centermap to a regular net1. Open the first centers map image if you closed it.2. With this image selected, press the button or selectProcess ⇒ Linearize... in the Menu. A new dialog box willbe opened (Figure 3).Figure 33. Press the Mark Vectors button and select three points asreference vectors. The first point will be the origin of bothvectors. Select these three points near the center of yourimage, where the non-linear effects are lower and look fortwo good vectors. To check the quality of the vectors,compare the ratio and angle shown in the dialog box withthe well known values. You can also select the first vectorand adjust the second one using these edit boxes.
Page 1 and 2: NANOTEC TECHNICAL NOTE 6 V1.0 1Non
Page 3: NANOTEC TECHNICAL NOTE 6 V1.0 3Obta
Page 7: Scanning with non-linear correction

How to use non-linear correction under WsxM

Create successful ePaper yourself

Delete template?

Save as template?