Infinity Operations Manual (96402,96403, 96406, 96407) - Whip Mix

SPECIFICATIONSINFINITY MElectrical 115V 50/60Hz 1075W230V 50/60Hz 1280WINFINITY L115V 50/60Hz 1392W230V 50/60Hz 1890WCapacity 8–1 3/4” rings or 2–3” rings 15–1 3/4” rings or5–1 3/4” rings and 3–3” ringOverallDimensionsHeatingChamberDimensionsINFINITY M AND LNumber of Programs 30NIGHT TIME(DELAY START)10.7”W x 10.2”D x 15.0”H(27.2cm x 26.9cm x 38.1cm)5-1/2”W x 5-1/4”D x 5-1/8”H(14.0cm x 13.3cm x 13.0cm)14.4”W x 11.0”D x 15.0”H(36.6cm x 28.0cm x 38.1cm)9-1/8”W x 5-1/4”D x 5-1/8”H(23.2cm x 13.3cm x 13.0cm)0 – 99 hoursNote: This is the time required for the program to be completedand ready to cast.HEAT RATE *(Stage 1)HEAT RATE *(Stages 2, 3, & 4)a) 1 – 30°F/min. (1 – 17°C/min.)b) “FULL” Stage heats at the maximum rate attainable.a) 1 – 30°F/min. (1 – 17°C/min.)b) “FULL” Stage heats at the maximum rate attainable.c) “NO” Stage is not used.d) “COOL” Stage cools down to the programmed temperature.Note: If “NO” is selected for a stage, that stage and all subsequentstages will not be used. The furnace, therefore, can be used for one,two, three or four stage operation.TEMPERATURE a) Stage 1: 150°F – 2012°F (66°C – 1100°C)b) Stage 2, 3, 4: 100°F – 2012°F (38°C – 1100°C)HOLD TIME0 – 4 hours* Programmable heat rates. Actual heat rate at high temperatures may be lower depending uponfurnace load and electrical voltage.ENVIRONMENTAL CONDITIONS• Indoor use• Altitude up to 2000 m• Temperature 5°C to 40°C (41°F to 104°F)• Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreasing linearlyto 50% relative humidity at 40°C (104°F)• Mains supply voltage fluctuations not to exceed +/– 10% of the nominal voltage• Pollution Degree 2, Installation Category II• Protection Degree IP20 – protected against objects greater than 12.5mm, no liquid protection3