User's Manual - Minarik

More documents

Recommendations

Info

Copyright © 1998 byMinarik CorporationAll rights reserved. No part of this manual may be reproduced or transmitted inany form without written permission from Minarik Corporation. The informationand technical data in this manual are subject to change without notice. MinarikCorporation and its Divisions make no warranty of any kind with respect to thismaterial, including, but not limited to, the implied warranties of its merchantabilityand fitness for a given purpose. Minarik Corporation and its Divisions assume noresponsibility for any errors that may appear in this manual and make nocommitment to update or to keep current the information in this manual.Printed in the United States of America.
Safety Warnings• This symbol denotes an important safety tip or warning.Please read these sections carefully prior to performing any ofthe instructions contained in that section.• Have a qualified electrical maintenance technician install,adjust and service this equipment. Follow the NationalElectrical Code and all other applicable electrical and safetycodes, including the provisions of the Occupational Safetyand Health Act (OSHA), when installing equipment.• Reduce the chance of an electrical fire, shock, or explosion byproper grounding, over-current protection, thermal protection,and enclosure. Follow sound maintenance procedures.• It is possible for a drive to run at full speed as a result of acomponent failure. Please ensure that a master switch hasbeen placed in the AC line to stop the drive in an emergency.• This drive is isolated from earth ground. Circuit potentialsare at 115 VAC above earth ground. Avoid direct contact withthe printed circuit board or with circuit elements to prevent therisk of serious injury or fatality. Use a non-metallic screwdriverfor adjusting the calibration trimpots.
Page 1: RG SeriesModels:RG25URG51UASCR, Adj
Page 5 and 6: iiiCalibration 19MAX SPD . . . . .
Page 7: vTablesFig Description Page1. Line
Page 10 and 11: 2DimensionsFigure 1. RG25U Dimensio
Page 12 and 13: 4Regenerative DrivesMost non-regene
Page 14 and 15: 6InstallationASSUMPTIONS: Minarik d
Page 16 and 17: 8 InstallationScrew terminal blockC
Page 18 and 19: 10 InstallationRG25U ConnectionsAC
Page 20 and 21: 12 InstallationRG51UA ConnectionsAC
Page 22 and 23: 14Block DiagramFigure 10. RG25U/RG5
Page 24 and 25: 16OperationBefore applying power1.
Page 26 and 27: 18 OperationRegenerative decelerati
Page 28 and 29: 20 CalibrationIf the time it takes
Page 30 and 31: 22CalibrationDBThe deadband trimmer
Page 32 and 33: 24 Application NotesOptional speed
Page 34 and 35: 26 Application NotesConnect two spe
Page 36 and 37: 28 Application NotesUse a single po
Page 38 and 39: 30 TroubleshootingMotor does not ru
Page 40 and 41: 32Replacement PartsReplacement part
Page 42 and 43: 34 Certificate of ComplianceAC Line
Page 44 and 45: 36 Certificate of ComplianceWhether
Page 46 and 47: 38Notes
Page 48: Other drives from Minarik Corporati

User's Manual - Minarik

Create successful ePaper yourself

Delete template?

Save as template?