Firewall - Check Point

SecurePlatformSecurePlatformIn This SectionInstallation, Upgrade and Backward Compatibility page 21Unicast Routing page 22Multicast Routing page 23ClusterXL page 24General page 26Installed Products page 28Unsupported Features page 28WebUI page 28Installation, Upgrade and Backward Compatibility1. In order to upgrade SecurePlatform NG FP2 or NG FP3 using the NG withApplication Intelligence CD, update the patch command before beginning theupgrade. In order to update the patch command, proceed as follows:1. Log into SecurePlatform.2. Place the CD into the CD drive.3. Enter the Expert mode.4. Type mount /mnt/cdrom.5. Type patch add/mnt/cdrom/SecurePlatform/patch/CPpatch_command_update.tgz6. Proceed with the patch add cd to upgrade the OS.This release note does not apply to upgrades performed via SmartUpdate.2. To upgrade an NG FP2 SecurePlatform machine, you need to apply aPre-Install-Patch on the machine before you start the upgrade process. You candownload the Pre-Install-Patch package from the download center.3. On Dell and IBM systems with the BIOS feature Console Redirection, this featuremust be disabled to use SecurePlatform with a serial console.4. When using the command line to upgrade, exiting the installation before it finishesplaces the system in an unstable state. Be sure to take a Snapshot of the systembefore beginning the upgrade (or answer Y when asked to create a backup image atthe beginning of the upgrade).5. To repeat an upgrade procedure (e.g., after a failed upgrade), install the updatedpatch command from the SecurePlatform CD. To install it, proceed as follows:Enterprise Suite NGX R61 Known Limitations Supplement Last Update — February 7, 2007 21