HM 1400 TRX Total Mercury Analyser - Webshop, Gas Analysis ...

2. Safety• The device as an entity and also its individual components may be usedonly when in their original configuration.2.5 Hazards due to electrical equipmentThe personnel assigned to carry out installation, commissioning andmaintenance must be totally familiar with all potential hazards and repairmeasures as set out in this manual.WARNINGDanger from electrical equipmentDanger from electric shocksBefore removing the housing or accidental-contact protection, the equipmentmust be disconnected from the power supply.If it cannot be disconnected, protective equipment must be worn to ensure theprevention of electric shocks.• The devices may only be connected to the supply voltage shown on thetype plate.• The devices may only be operated on a power supply with an earthingcontact. The protective action must not be cancelled by an extensionwithout a protective earth conductor. Any interruption in the protectiveearth conductor inside or outside the device is dangerous and is notpermitted.• Cables should be laid so that risk of accident due to tripping or gettingcaught on the lines is excluded.ATTENTION!Damage to electronic components due toelectrostatic discharge (ESD)Electronic components are becoming increasingly small and complex. Theirsusceptibility to damage from electrostatic discharge is increasingaccordingly. To protect these components, measures to prevent electrostaticdischarge must be taken before starting any work on the opened device (ESDprotection).As a precaution against electrostatic discharge from the human body, serviceemployees should be equipped with a personal earthing system.2.6 Hazard from hot, aggressive, explosive gases or highmeasuring gas pressureWARNINGRisk of explosion due to explosive atmosphere!An explosive atmosphere can endanger the health and safety of personnel.Use of the total mercury analyser HM 1400 TRX in potentially explosive areasand measurement in and of explosive gas mixtures is not permitted.• The Total Mercury Analyser is connected to the exhaust gas channel bythe sampling probe and the measuring gas line. In the case of systemswith a low danger potential (ambient pressure, low temperatures, nohealth hazard), mounting/removal can occur during system operation. Theapplicable provisions and safety regulations for the system must becomplied with and any necessary and appropriate protective measures taken.HM 1400 TRX 21