Title: Quick Guide to Setup a Cross-Platform SAN - SupportConnect

More documents

Recommendations

Info

8. After the primary server has initialized, run csetup on each ofthe distributed servers, one at a time. Make sure that the orderin which you enter the server names on the primary server isthe same on all of the distributed servers.If the number of distributed servers is large, you may copy thesanpeer.cfg file from the UNIX primary server to all of theUNIX distributed servers. This will ensure that the order ofUNIX distributed server names will be identical on all themembers.You will see only two sanpeer processes on the distributedservers. The sanghost process does not run on the distributedservers. After the SAN configuration is completed on thedistributed servers, continue with the library configuration (asperformed on the primary server), and then start the BrightStorEnterprise Backup processes on that server.Notes:• Before starting BrightStor Enterprise Backup on one server,make sure that all of the processes (on the previouslyconfigured server) are up and running, and that the serversees the devices properly.• In a Cross-Platform environment, the UNIX primary serveracts as the primary server. On Windows NT, the primaryserver acts as a distributed server to the UNIX primaryserver. To set up this configuration, from the sansetupprogram, you must answer yes to the following question inthe script:
We can add your NT primary server in a SAN environment to ourlist of UNIX Distributed Servers in a SAN environment. Pleasenote that the NT server must be a SAN NT primary server, not aSAN NT distributed server.Do you wish to add any SAN NT primary server at this time?[y,n,?,q] yWhat is the name of your SAN NT primary server? w2k_svrThis is your configuration.[MemberNames]## Primary Server ##server1=UXLEXUS_SC430server2=UXRX330server3=UXPathfinderserver4=NTHackie[EnterpriseSetup]Is your primary server, number of distributed servers, and thenames of your distributed servers correct? (y|n|q) yYour SAN setup has been configured.To configure your Windows server(s) on a Cross-PlatformSAN, follow the steps in the next section, “WindowsInstallation on a Cross-Platform”.
Page 3 and 4: Implementation StepsIP connectivity
Page 5: UNIX Installation and Configuration
Page 9 and 10: The Add Servers dialog appears. For
Page 12 and 13: F. Repeat Step D and E to assign th
Page 14 and 15: Notes:7. After the Cross-Platform p

Title: Quick Guide to Setup a Cross-Platform SAN - SupportConnect

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?