Picture Perfect 4.6 Enterprise Edition User Manual - UTCFS Global ...

More documents

Recommendations

Info

66Picture Perfect 4.6 Enterprise EditionUser ManualVerifying Remote Database Connectivity... [ OK ]Verifying /etc/hosts...bctdover [ OK ]bctalford [ OK ]Verifying /cas/.netrc ...bctdover [ OK ]Verifying /cas/ppapp/.netrc ...bctdover [ OK ]Verifying system_config count... [ OK ]Verifying Table ID Consistency... [ OK ]Verifying host count... [ OK ]Verifying Host Record Consistency...bctdover Startup Mode... [ OK ]Configure Host... [ OK ]bctalford Startup Mode... [ OK ]Configure Host... [ OK ]Verifying Increased Categories Settings... [ ENABLED ]Verifying Seed Counter Settings... [ DISABLED ]Verifying /etc/services...bctdover [ OK ]bctalford [ OK ]Verifying NTP config file exists... [ OK ]Verifying Nethost configured in /etc/ntp.conf... [ OK ]Verifying NTP daemon is running... [ OK ]Verifying Informix ER configuration... [ OK ]Results: Passed [ 45 ], Failed [ 0 ], Blocked [ 0 ]Note the Results line listed at the end of the output.• If the Failed column lists 0, then the installation is successful.• If the Failed column lists a number greater than 0, then problems have been detected in yourconfiguration. Refer to Table 6, Verification Tests and see the sections referenced by eachtest for troubleshooting details.Table 6.Verification TestsTestVerifying Network ConnectionVerifying Remote Connectivity by SSHVerifying Operating System TypeResultThis test fails if a subhost cannot be reached using the ping command. If thistest fails, then there is either a networking configuration problem on thenethost or on the target subhost or both.This test fails if a subhost cannot be reached by SSH. SSH access is requiredfor chkenterprise to verify conditions on a subhost. Enable SSH access tothe subhost and try again.This test can fail only if chkenterprise is being executed on a system thatis neither Linux nor AIX. Currently, Enterprise system is supported only on theLinux and AIX operating systems.Verifying TPS is running Please see Verifying Picture Perfect on page 70.Verifying Informix is running Please see Verifying Picture Perfect on page 70.
Chapter 5Verifying the configuration67Table 6.Verification Tests (continued)TestVerifying Remote Database ConnectivityResultThis test can fail only if either the /cas/db/etc/sqlhosts file or the /etc/services file is configured incorrectly. Failure indicates that the nethostcannot remotely access the subhost database.Please see Verifying remote database access configuration on page 77.Verifying /etc/hosts Please see Verifying Enterprise system setup on page 73 and File setup of /etc/hosts on page 73.Verifying .netrcPlease see Verifying Enterprise system setup on page 73 and File check of.netrc on page 73.Verifying system_config count Please see Verifying table IDs on page 75.Verifying Table ID consistency Please see Verifying table IDs on page 75.Verifying Host Record consistencyVerifying Seed Counter SettingsThis test can fail only if either the Startup Mode or Configure Host field for aparticular host record have been misconfigured. Refer to page 12, StartupMode, and page 12, Configure Host, for information on how to properlyconfigure these fields of the Hosts form for a nethost or subhost record.This test determines whether or not Seed Counter is enabled or disabled. Allsystems in an Enterprise system must have the same Seed Counter settings.If a mismatch is detected, a warning is displayed indicating that all hosts in anEnterprise system must have identical Seed Counter settings. To correct thisproblem, reinstall the mismatched host or hosts.Verifying /etc/services Please see Verifying remote database access configuration on page 77.Verifying of hosts time synchronization Please see Verifying hosts time synchronization on page 79.Verifying Informix ER configurationThis test verifies the ER related configuration for all configured ER hosts fromnethost, namely:• replicate definition• ER sever state• host_time table entries• ER log directory• ER cron job• ER Db space• ER Db task• ER sysadmin procedures• ER store procedures• ER Db triggers• ER Db syssequences for ER related tablesIf chkenterprise fails during Verifying Informix ER configuration for asingle host, then we recommend running the /cas/er/bin/er_verify_install_on_nethost.sh -s hostname script to identifythe ER configuration problem for this host.If chkenterprise fails during Verifying Informix ER configuration for allconfigured ER hosts, then we recommend running /cas/er/bin/er_verify_install_on_nethost.sh to identify the ER configurationproblem.A log file named erVerifyInstall.log is generated in the /cas/log/directory. Refer to this log file for more details.
Page 1:
Picture Perfect 4.6 Enterprise Edit
Page 5 and 6:
iiiChapter 6. Troubleshooting and s
Page 7 and 8:
iPrefaceThis document is designed t
Page 9 and 10:
Chapter 1 Enterprise system overvie
Page 11 and 12:
Chapter 1Enterprise system overview
Page 13 and 14:
Chapter 2 Installing the Picture Pe
Page 15 and 16:
Chapter 2Installing the Picture Per
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24: Chapter 2Installing the Picture Per
Page 34 and 35: 26Picture Perfect 4.6 Enterprise Ed
Page 108 and 109: 100Picture Perfect 4.6 Enterprise E
Page 124 and 125:
116Picture Perfect 4.6 Enterprise E
Page 126:
118Picture Perfect 4.6 Enterprise E
show all

Picture Perfect 4.6 Enterprise Edition User Manual - UTCFS Global ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?