Picture Perfect 4.6 Enterprise Edition User Manual - UTCFS Global ...

Chapter 2Installing the Picture Perfect Enterprise system23Adding a new subhost or adding back a crashed or removed subhost after the network is configuredWhen a new subhost is added to an existing network configuration, the subhost package isinstalled on the new subhost. Then the Enterprise system is configured to include this subhost.PrerequisitesBefore installing subhost, the Picture Perfect base package must be installed on the subhost.Update the host table on the nethost with subhost informationRefer to Update the host table on the nethost with subhost information on page 11.Install the subhost package on the new subhostRefer to Install the subhost package on each subhost after the base package has been installed onpage 14.Shut down and reboot the new subhostRefer to Shut down and reboot all subhosts on page 18.Use the hostconfig utility on the nethost to add the new subhost to the networkRefer to Using the hostconfig utility on the nethost to add the subhosts to the network on page 19.Restart Picture Perfect on the nethost and all subhostsRefer to Restart Picture Perfect on the nethost and all subhosts on page 22.Your system should now be ready. Your nethost and subhost should be communicating.To verify the Picture Perfect Enterprise configuration, refer to Chapter 5, Verifying the configurationand run the Running chkenterprise utility.Enterprise system printer installationIn an Enterprise system with more than one host, AIX and Linux can be configured to forward printrequests from one host to another. This makes it possible for all hosts to use a single printer attachedto one host, or for a single host to print to many printers attached to different hosts. Before setting upEnterprise system printing, define all printers locally, at the host to which they are physicallyattached.Refer to the Picture Perfect 4.6 Installation Manual for instructions on configuring your system forprinters.