Patterned and switchable surfaces for biomaterial applications

More documents

Recommendations

Info

)sChapter 2 – Spatially t controlled electro-stimulated DNA adsorption and desorption for biodevicenapplicationsuoc((A)(B)1000yti 800sn 600etn 400I) 200st 0nuoc(1000yti 800sn 600etn 400I2000O-C=O290O-C=O290C=O288 286Binding Energy (eV)C=OC-NC-OC-NC-O288 286Binding Energy (eV)C-HC-CFigure 2.4. High-resolution C 1s spectra for Si modified with A) ALAPP, B) PEGgrafted onto ALAPP. Curves fitted with four components.284C-HC-C2842822822-78
Andrew Hook – Patterned and switchable surfaces for biomaterial applicationsTo further characterise the chemical functionality of the plasma polymer films,ALAPP films were analysed by FT-IR. A typical spectrum for an ALAPP filmdeposited on a KBr disk is shown in Figure 2.5. The large width of adsorption bandsis characteristic of the highly cross-linked plasma polymer [183]. An assignment ofpeaks is given in Table 2.3. Of significance are the large amine signals observed at1100 cm -1 and 3040-3500 cm -1 whilst the minimal imide and amide signal seen at1550-1750 cm -1 and the absence of a nitrile signal at 2100 cm -1 , suggesting that thenitrogen present with the ALAPP is predominantly in an amine form. However,conclusive quantitative results for FT-IR results are difficult due to the uncertainty ofabsorbance coefficients, thus, although FT-IR does further confirm the presence ofamine functionality, it does not conclusively show the extent to which imine andamide functionalities can be found on the ALAPP film. A much lower imine, amideand nitrile signal is reported compared to previously reported studies [180, 185, 186].Significant differences between the present procedure and previously usedprocedures include an alteration in the radio-frequency used to generate the plasma,200 kHz as compared with 13.56 MHz, and a much lower input power of 20 W ascompared with 200 W. This may result in less fragmentation of the monomer and agreater preservation of functional groups as well as the reduced production ofreactive species that can result in post-deposition alterations to the film.2-79
Page 1 and 2:
Patterned andswitchable surfacesfor
Page 3 and 4:
TABLE OF CONTENTSTABLE OF CONTENTS
Page 5 and 6:
Andrew Hook - Patterned and switcha
Page 7 and 8:
Page 9 and 10:
Page 12 and 13:
CHAPTER 1.INTRODUCTION1The content
Page 14 and 15:
Chapter 1 - Introductionconsiderabl
Page 16 and 17:
Chapter 1 - Introductioninteraction
Page 18 and 19:
Chapter 1 - IntroductionIn general,
Page 20 and 21:
Chapter 1 - IntroductionFor some ap
Page 22 and 23:
Chapter 1 - Introductionangles rang
Page 24 and 25:
Chapter 1 - Introductionof understa
Page 26 and 27:
Chapter 1 - IntroductionSeveral str
Page 28 and 29:
Chapter 1 - Introductioncues to con
Page 30 and 31:
Chapter 1 - Introductionby controll
Page 32 and 33:
Chapter 1 - Introduction1.2.2. Soft
Page 34 and 35:
Chapter 1 - Introductionsubstrate.
Page 36 and 37:
Chapter 1 - Introduction(A)(B)Figur
Page 38 and 39: Chapter 1 - Introduction(A)(B)(C)(C
Page 40 and 41: Chapter 1 - Introductioncomplex gen
Page 42 and 43: Chapter 1 - Introductionmorphology
Page 44 and 45: Chapter 1 - Introduction(A)(B)(C)(D
Page 46 and 47: Chapter 1 - Introductionthe LCST, a
Page 48 and 49: Chapter 1 - IntroductionHyun et al.
Page 50 and 51: Chapter 1 - Introductionmicelles. T
Page 52 and 53: Chapter 1 - Introduction1.4.1. DNA
Page 54 and 55: Chapter 1 - IntroductionA major pro
Page 56 and 57: Chapter 1 - Introductionattached to
Page 58 and 59: Chapter 1 - IntroductionTable 1.1.
Page 60 and 61: Chapter 1 - Introductionefficiencie
Page 62 and 63: Chapter 1 - Introductionachieved by
Page 64 and 65: Chapter 1 - IntroductionTable 1.2.
Page 66 and 67: Chapter 1 - IntroductionOnce releas
Page 68 and 69: Chapter 1 - Introductionimaging not
Page 70 and 71: Chapter 1 - IntroductionA number of
Page 73 and 74: CHAPTER 2.SPATIALLY CONTROLLED ELEC
Page 75 and 76: Andrew Hook - Patterned and switcha
Page 87: Andrew Hook - Patterned and switcha
Page 107 and 108: CHAPTER 3.COMPARISON OF THE BINDING
Page 123 and 124: DNA (mg/m 2 ) DNA (mg/m 2 )Andrew H
Page 131 and 132: DNA (mg/m 2 )Andrew Hook - Patterne
Page 137: Andrew Hook - Patterned and switcha
Page 140 and 141:
Chapter 4 - Formation of a chemical
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 165 and 166:
CHAPTER 5.SURFACE PLASMON RESONANCE
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
SPR signal intensity (counts)Andrew
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Reflectivity (%) Reflectivity (%)An
Page 195 and 196:
Reflectivity (%)SPR signal intensit
Page 197 and 198:
SPR signal intensity (counts)Andrew
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Thickness (nm)Thickness (nm)Thickne
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 218 and 219:
CHAPTER 6.OVERALL CONCLUSIONS6.6An
Page 220 and 221:
Chapter 6 - Overall conclusionsThes
Page 222 and 223:
Chapter 6 - Overall conclusionsnew
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Force (nN)Force (nN)Force (nN)Force
Page 234 and 235:
Force (nN)Force (nN)Andrew Hook - P
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
show all

Patterned and switchable surfaces for biomaterial applications

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?