Hanging Platform - Combisafe

AssemblyCombisafe Hanging PlatformCheck that the roof truss is free from cracks and knots or other defects that mightaffect strength.1. Drill a 13 mm hole in the roof truss end as per the picture below. The dimensionsrefer to the distance from the hole to the edge of the roof truss. In thedirection of the grain this must be at least 120 mm, and the distance at rightangles to the grain must be at least 60 mm.4060120=602100_018[mm]Ø 1345-150Figure 23. Dimensional draft2. Place the Hanging Platform Clamp over the hole. The Hanging PlatformClamp can be placed in two different directions depending on which side ofthe roof truss you want to suspend the Hanging Platform Console, as well aswhere the support to the facade ends up.3. Attach the Hanging Platform Clamp using the M12x200 screw through thehole. Thread the M12 screw in the clamp screw's internal thread to the bottom.Check that the Hanging Platform Clamp is hanging plumb and tightensecurely.Figure 24. Placement of Hanging Platform Clamp28