TTG-7000 operation manual - AvionTEq

Menu Control Function8 Latitude. Range from -90 to 90 degrees.9 Longitude. Range from -180 to 180 degrees.10 Vertical Speed numeric box. Range from – 32576 to 32576 ft/min in 64 ft/min steps.Used only for the velocity squitter, since the intruder is static.11 Velocity numeric box. Range 0 to 2000 knots. Used only for the velocity squitter, sincethe intruder is static.12 Track Angle numeric box. Value range from -180 to 180 degrees in 1-degree steps.Used only for the velocity squitter, since the intruder is static.13 Squitter Power numeric box. Low power range -20 to -90 dBm in 1 dB steps. Highpower range from 1 to -69 dBm.14 Squitter Antenna combobox. (Top Only, Bottom Only, Both)15 Start/Stop Time.16 Enable. If checked then test set will transmit the required messages for this intruder.17 Altitude Report checkbox. If enabled the altitude code will be present in the DF0 reply.If disabled the altitude code will set to 0.18 Ground checkbox allows the user to set VS bit for the intruder.19 Squitter checkbox. If enabled squitter are active.20 DO-260 Mode. (Version -, A, or B).21 Mode S Address numeric box.22 Squitter Probability Pattern combobox. (Values: 1.0, 0.8, 0.6, 0.4, 0.2)23 Altitude Mode switch. (Gilham or Binary)24 Intruder Identification25 Vertical Velocity26 Velocity Type27 Utility Message (UM) Field28 Downlink Request (DR) Field29 Position Type combobox (ADS-B, Fine, or Coarse).30 Flight Status (FS) Field31 Transponder Capability (CF) FieldSoftkeyFunctionType Same as menu control item 1Number Same as menu control item 2Enable Same as menu control item 16Mode Same as menu control item 3Starting At Same as menu control item 15Stopping At Same as menu control item 15Squitter Same as menu control item 19Altitude Report Same as menu control item 17Ground Same as menu control item 18DO-260 Mode Same as menu control item 20Mode S Address Same as menu control item 21Tx Channel Same as menu control item 4TTG-7000 User’s Manual Page 9790-7000-0001 Rev E