TTG-7000 operation manual - AvionTEq

Menu Control Functionintruders is 568.6 Number of static intruders enabled7 Number of Ground Stations defined for the scenario. Maximum number of groundstations is 15.8 Number of Ground Stations enabled9 Number of Video Blocks. Maximum number of Video Blocks is 12.10 Capture Squitters and Datalogging checkbox allows the user to log all the messagesreceived during the scenario according to the message mask assigned in the Receivermenu. The data log is reset at the start of scenario.11 Fruit enable/disable checkbox12 ATE Line Synchronization checkbox. If synchronization is enabled, then all scenariorun time is synchronized to TCAS TISI sequence. (ATE Lines need to be attached totest set)13 Slant Range. If enabled the TTG-7000 calculates the range using the intruder range,intruder altitude, and own aircraft altitude. If disabled the range is the horizontalrange that is defined in the intruder definition.14 Number of Video Blocks enabled.15 Power Mode. The user can select between high or low power modes. High powermode allows output of 1 to -69 dBm and low power allows -20 to -90 dBm.16 Sets the TTG-7000 to allow dual antenna; top only or bottom only setup.17 Coordination Repetition Interval is the time interval between coordinationinterrogations if TCAS system does not reply. The maximum number of repetition isten (10) interrogations. Interval range from 1000 to 65000 microseconds. Default is10000 microseconds.18 Squitter Spacing. Allows setting the time spacing between squitters from 200 to 500microseconds. Default is 200 microseconds.19 Own Aircraft Source Combobox. Allows the own aircraft data to be entered manually,through 429, or external (TCP/IP).20 Static Mode. Static mode allows the dynamic intruders to stay active after theruntime has reached the scenario time with their last position.21 Special Test Combobox [Customer Specific]22 Waypoint Definition. Allows setting waypoints either by time, location (latitude andlongitude realistic airplane simulation) or forced trajectory (latitude and longitudepass over).23 Video Data Bit Period. Allows setting the period of a Video Block Data Bit to either 25or 50 nanosecond.SoftkeyLoadSaveResetFunctionOpens a file dialog to allow the user to load asaved scenario configuration.Allows saving the current scenario configuration toa file.Resets all intruders, ground stations, and videoTTG-7000 User’s Manual Page 5790-7000-0001 Rev E