TTG-7000 operation manual - AvionTEq

More documents

Recommendations

Info

SoftkeyFunctionRandom Start See menu control 2.Random Width See menu control 2.Figure 3.1.2.4.1.8 illustrates the RTCA/DO-260 Generator Definition Menu. This menu allows theoperator to specify the generator parameters for delay triggering.123489567Figure 3.1.2.4.1.8 – RTCA/DO-260 Generator Definition Menu for Delay TriggeringMenu Control Function1 Generator combobox allows selection of generator.2 Power numeric box allows setting the output power of the generator.3 Phase numeric box allows setting the output phase of the generator.4 Path combobox allows setting the path of the generator to top or bottom.5 Delay numeric box allows setting the delay from the trigger source. If the generatorthat is being set is the trigger source, this parameter is disabled. The delay value willbe either positive or negative in accordance with the setting in the timing definitionof delay+ or delay-. The range is from 0 to 120000 nanoseconds in 100 nanosecondsteps.6 Message Type combobox allows selecting between Mode S or ATCRBS message. Ifthe generator that is being set is the trigger source, this parameter is disabled and setto Mode S.TTG-7000 User’s Manual Page 4890-7000-0001 Rev E
Menu Control Function7 Message Definition section allows the operator to set the message. For Mode S theparameters that can be set are Mode S Address, Mode S Message Type, and whetherthe data is random excluding the first five bits and the PI field. For ATCRBS theparameters that can be set are Mode A Code or random (2 frame pulses with 5random data pulses).8 Enable checkbox allows enabling or disabling the generator for the test. If thegenerator selected is the trigger source, this parameter is disabled and the generatoris enabled.9 Random Starting Position will change the starting position of each message from thedelay value.SoftkeyFunctionGenerators Same as menu control item 1.Enable Same as menu control item 8.Power Same as menu control item 2.Phase Same as menu control item 3.Path Same as menu control item 4.Delay Same as menu control item 5.Message Type Same as menu control item 6.Mode S See menu control item 7.RandomSquitter NameMode SAddressFrame DetailsMode A/Mode C See menu control item 7.RandomABCDIdentRandom Starting Position Same as menu control item 9.TTG-7000 User’s Manual Page 4990-7000-0001 Rev E
Page 1 and 2: USER’S MANUALFORTTG-7000 TCAS\TRA
Page 3 and 4: 3.1.2.5.10. Dynamic ADS-R Definitio
Page 5 and 6: 1. OverviewThe TTG-7000 TCAS\Transp
Page 7 and 8: Resolution:Accuracy:0.1 dB1 dBRelat
Page 9 and 10: 123645798111012Figure 2.2 - TTG-700
Page 11: Figure 2.5 - TTG-7000 429 Input Ada
Page 15 and 16: Figure 3.1.3 - Safely Remove Hardwa
Page 17 and 18: Menu Controls Functionsbe used on f
Page 19 and 20: Note: If you place the cursor in th
Page 21 and 22: For example, user wants to change t
Page 23 and 24: 3.1.2. TCAS Main MenuFigure 3.1.2.1
Page 25 and 26: 3.1.2.1. TCAS Settings Menu12Figure
Page 27 and 28: SoftkeyFunctionPhaseExt. ModGenerat
Page 29 and 30: Menu Control Function5 Heading nume
Page 31 and 32: SoftkeyFunctionAltitude Same as men
Page 33 and 34: SoftkeyCaptureDisplayData LoggingUU
Page 35 and 36: 3.1.2.3.1. TCAS Receiver Filtered M
Page 37 and 38: 3.1.2.3.2. TCAS Receiver Highlight
Page 39 and 40: 3.1.2.4. TCAS Transmitter MenuFigur
Page 41 and 42: SoftkeySpecial Test DefinitionTimin
Page 43 and 44: SoftkeyPulse 1 WidthPositionPowerEn
Page 45 and 46: Figure 3.1.2.4.1.5 illustrates the
Page 47: Figure 3.1.2.4.1.7 illustrates the
Page 51 and 52: Menu Control Function8 Enable check
Page 53 and 54: SoftkeyFunctionRemoveRemoves the se
Page 55 and 56: Figure 3.1.2.4.2.3 illustrates the
Page 57 and 58: Menu Control Functionintruders is 5
Page 59 and 60: 3.1.2.5.1. Static Mode S TCAS Only
Page 61 and 62: SoftkeyFunctionDF16 Reply Message M
Page 63 and 64: SoftkeyFunctionReply LengthAllows s
Page 65 and 66: 3.1.2.5.1.2. Broadcast MessageFigur
Page 67 and 68: SoftkeyMU-HSBMU-VSBMU-MIDFunctionTT
Page 69 and 70: SoftkeyFunctioncoordination replies
Page 71 and 72: SoftkeyReply LengthAcquisition Spec
Page 73 and 74: Menu Control Function7 Range numeri
Page 75 and 76: 3.1.2.5.3. Static Mode C Definition
Page 77 and 78: SoftkeyFunctionMode A Code (D) Same
Page 79 and 80: Menu Control Function10 Vertical Sp
Page 81 and 82: 3.1.2.5.5. Static Mode S Extended D
Page 83 and 84: Menu Control Function40 CA FieldSof
Page 85 and 86: 3.1.2.5.5.1. Mode S Squitter Defini
Page 87 and 88: 3.1.2.5.5.3. Velocity Squitter Defi
Page 89 and 90: 3.1.2.5.5.4. Ident Squitter Definit
Page 91 and 92: 3.1.2.5.5.5. BDS Register Definitio
Page 93 and 94: Menu Control Function5 Altitude num
Page 95 and 96: SoftkeyFunctionTransponder Capabili
Page 97 and 98: Menu Control Function8 Latitude. Ra
Page 99 and 100:
3.1.2.5.8. Dynamic TIS-B Definition
Page 101 and 102:
SoftkeyFunctionIdent Format Type Sa
Page 103 and 104:
Menu Control Function8 Latitude. Ra
Page 105 and 106:
3.1.2.5.10. Dynamic ADS-R Definitio
Page 107 and 108:
SoftkeyFunctionAltitude Same as men
Page 109 and 110:
3.1.2.5.12. TCAS Ground Station Men
Page 111 and 112:
SoftkeyFunctioncontents.TTG-7000 Us
Page 113 and 114:
SoftkeyResetF1 Pulse C1 Pulse A1 Pu
Page 115 and 116:
SoftkeyFunctionTx Channel Same as m
Page 117 and 118:
Menu Control Function10 Vertical Sp
Page 119 and 120:
SoftkeyFunctionVideo Block Number S
Page 121 and 122:
3.1.2.6. TCAS ATE Line MenuFigure 3
Page 123 and 124:
3.1.2.7. TCAS Chamber Mode MenuFigu
Page 125 and 126:
3.1.2.8. Measurement MenuFigure 3.1
Page 127 and 128:
123478956Figure 3.1.2.8.2 - Measure
Page 129 and 130:
3.1.3. Transponder MenuFigure 3.1.3
Page 131 and 132:
Menu Control Function5 Tx Path allo
Page 133 and 134:
Menu Control Function8 Suppression
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Menu Control Functionsteps. Power d
Page 143 and 144:
Menu Control Functionsteps. Power d
Page 145 and 146:
Menu Control Function9 Interrogatio
Page 147 and 148:
3.1.4.1. UAT SettingsFigure 3.1.4.1
Page 149 and 150:
3.1.4.2. UAT Receiver MenuFigure 3.
Page 151 and 152:
SoftkeyFiltered Masked MenuHighligh
Page 153 and 154:
SoftkeyFunctionAltitude Same as men
Page 155 and 156:
Menu Control Functionsaved file.9 U
Page 157 and 158:
Menu Control Function12 NIC13 Uplin
Page 159 and 160:
Figure 3.1.4.4.1.3 illustrates the
Page 161 and 162:
SoftkeyFunctionType Same as menu co
Page 163 and 164:
SoftkeyFunctionType Same as menu co
Page 165 and 166:
5. If all devices enabled in the co
Page 167 and 168:
10. If the scenario terminates, the
Page 169 and 170:
LatitudeLongitude-90 to 90 degrees-
Page 171 and 172:
Stop at Scenario Duration 0 to Scen
Page 173 and 174:
Identification CodeStatic (STAxxx)
Page 175 and 176:
Note: That for all intruders the lo
Page 177 and 178:
Figure 4.2 - VNC Viewer Connection
Page 179 and 180:
5. TEST CONFIGURATIONSTTG-7000 User
Page 181 and 182:
TCAS/Hybrid Surveillance/ITP Versio
Page 183:
TCAS Coordinated RA Test Configurat
show all

TTG-7000 operation manual - AvionTEq

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?