TTG-7000 operation manual - AvionTEq

More documents

Recommendations

Info

Menu Control Function2 Power Mode Combobox allows the user to select between high or low power modes.Low power allows setting the output power from -20 to -90 dBm. High power allowssetting the power from 1 to -69 dBm.3 Receiver Path Combobox allows the user to select which port to connect theTop/Bottom Receiver. Selections available are Rx T1/B1, Rx T2/B2, Rx T3/B3, RxT4/B4, Chamber, or Combiner. Note : On Collins Magnitude or ACSS this setting isautomatically switched to Combiner.4 Phase Noise Amplitude. Future use.5 Suppression Out On/Off. Future use.6 Tx Frequency Numeric Box allows the setting of the Transmitter frequency. Individualsetting for each transmitter. Range from 962 to 1213 MHz in 0.1 MHz steps.7 Tx Power Numeric Box allows the setting of the Transmitter power from -20 to -90dBm in 1 dB steps in low power mode or from 1 to -69 dBm in 1 dB steps in highpower mode.8 Tx Path allows setting the Tx path to Top All Ports/Bottom All Ports/Single Port.Selections are T1, T2, T3, T4, Top (All), B1, B2, B3, B4, and Bottom (All).9 External Modulation On/Off. Future use.10 Phase (Bearing) for the specific Transmitter. Range 0 to 359 degrees in 1-degreesteps.11 Modulation CW/Pulse12 Signal Generator On/Off13 Pulse Risetime/Falltime slow or normal.14 Pulsewidth Combobox allows the user to adjust the pulsewidth of all thetransmissions by +/- 100 nanoseconds in 25 nanosecond steps.SoftkeyFactory SetupSignal Generator MenuGenerator AOn/OffFrequencyModulationPathPowerPhaseRise/FallExt. ModGenerator BOn/OffFrequencyModulationPathPowerFunctionSets all hardware to default setting according tohardware configuration.Same as menu control item 12.Same as menu control item 6.Same as menu control item 11.Same as menu control item 8.Same as menu control item 7.Same as menu control item 10.Same as menu control item 13.Same as menu control item 9.Same as menu control item 12.Same as menu control item 6.Same as menu control item 11.Same as menu control item 8.Same as menu control item 7.TTG-7000 User’s Manual Page 2690-7000-0001 Rev E
SoftkeyFunctionPhaseExt. ModGenerator CGenerator DGenerator EGenerator FSame as menu control item 10.Same as menu control item 9.Same as Generator A.Same as Generator B.Same as Generator A.Same as Generator B.OEM Select Same as menu control item 1.Power Mode Same as menu control item 2.Receiver Path Same as menu control item 3.Suppression OutFuture use.Phase NoiseFuture use.Pulsewidth Same as menu control item 14.Note: Selection of OEM changes the Antenna Simulation module, the antenna resistors, and loads thecalibration tables for bearing for the selected OEM.TTG-7000 User’s Manual Page 2790-7000-0001 Rev E
Page 1 and 2: USER’S MANUALFORTTG-7000 TCAS\TRA
Page 3 and 4: 3.1.2.5.10. Dynamic ADS-R Definitio
Page 5 and 6: 1. OverviewThe TTG-7000 TCAS\Transp
Page 7 and 8: Resolution:Accuracy:0.1 dB1 dBRelat
Page 9 and 10: 123645798111012Figure 2.2 - TTG-700
Page 11: Figure 2.5 - TTG-7000 429 Input Ada
Page 15 and 16: Figure 3.1.3 - Safely Remove Hardwa
Page 17 and 18: Menu Controls Functionsbe used on f
Page 19 and 20: Note: If you place the cursor in th
Page 21 and 22: For example, user wants to change t
Page 23 and 24: 3.1.2. TCAS Main MenuFigure 3.1.2.1
Page 25: 3.1.2.1. TCAS Settings Menu12Figure
Page 29 and 30: Menu Control Function5 Heading nume
Page 31 and 32: SoftkeyFunctionAltitude Same as men
Page 33 and 34: SoftkeyCaptureDisplayData LoggingUU
Page 35 and 36: 3.1.2.3.1. TCAS Receiver Filtered M
Page 37 and 38: 3.1.2.3.2. TCAS Receiver Highlight
Page 39 and 40: 3.1.2.4. TCAS Transmitter MenuFigur
Page 41 and 42: SoftkeySpecial Test DefinitionTimin
Page 43 and 44: SoftkeyPulse 1 WidthPositionPowerEn
Page 45 and 46: Figure 3.1.2.4.1.5 illustrates the
Page 49 and 50: Menu Control Function7 Message Defi
Page 51 and 52: Menu Control Function8 Enable check
Page 53 and 54: SoftkeyFunctionRemoveRemoves the se
Page 57 and 58: Menu Control Functionintruders is 5
Page 59 and 60: 3.1.2.5.1. Static Mode S TCAS Only
Page 61 and 62: SoftkeyFunctionDF16 Reply Message M
Page 63 and 64: SoftkeyFunctionReply LengthAllows s
Page 65 and 66: 3.1.2.5.1.2. Broadcast MessageFigur
Page 67 and 68: SoftkeyMU-HSBMU-VSBMU-MIDFunctionTT
Page 69 and 70: SoftkeyFunctioncoordination replies
Page 71 and 72: SoftkeyReply LengthAcquisition Spec
Page 73 and 74: Menu Control Function7 Range numeri
Page 75 and 76: 3.1.2.5.3. Static Mode C Definition
Page 77 and 78:
SoftkeyFunctionMode A Code (D) Same
Page 79 and 80:
Menu Control Function10 Vertical Sp
Page 81 and 82:
3.1.2.5.5. Static Mode S Extended D
Page 83 and 84:
Menu Control Function40 CA FieldSof
Page 85 and 86:
3.1.2.5.5.1. Mode S Squitter Defini
Page 87 and 88:
3.1.2.5.5.3. Velocity Squitter Defi
Page 89 and 90:
3.1.2.5.5.4. Ident Squitter Definit
Page 91 and 92:
3.1.2.5.5.5. BDS Register Definitio
Page 93 and 94:
Menu Control Function5 Altitude num
Page 95 and 96:
SoftkeyFunctionTransponder Capabili
Page 97 and 98:
Menu Control Function8 Latitude. Ra
Page 99 and 100:
3.1.2.5.8. Dynamic TIS-B Definition
Page 101 and 102:
SoftkeyFunctionIdent Format Type Sa
Page 103 and 104:
Menu Control Function8 Latitude. Ra
Page 105 and 106:
3.1.2.5.10. Dynamic ADS-R Definitio
Page 107 and 108:
SoftkeyFunctionAltitude Same as men
Page 109 and 110:
3.1.2.5.12. TCAS Ground Station Men
Page 111 and 112:
SoftkeyFunctioncontents.TTG-7000 Us
Page 113 and 114:
SoftkeyResetF1 Pulse C1 Pulse A1 Pu
Page 115 and 116:
SoftkeyFunctionTx Channel Same as m
Page 117 and 118:
Menu Control Function10 Vertical Sp
Page 119 and 120:
SoftkeyFunctionVideo Block Number S
Page 121 and 122:
3.1.2.6. TCAS ATE Line MenuFigure 3
Page 123 and 124:
3.1.2.7. TCAS Chamber Mode MenuFigu
Page 125 and 126:
3.1.2.8. Measurement MenuFigure 3.1
Page 127 and 128:
123478956Figure 3.1.2.8.2 - Measure
Page 129 and 130:
3.1.3. Transponder MenuFigure 3.1.3
Page 131 and 132:
Menu Control Function5 Tx Path allo
Page 133 and 134:
Menu Control Function8 Suppression
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Menu Control Functionsteps. Power d
Page 143 and 144:
Menu Control Functionsteps. Power d
Page 145 and 146:
Menu Control Function9 Interrogatio
Page 147 and 148:
3.1.4.1. UAT SettingsFigure 3.1.4.1
Page 149 and 150:
3.1.4.2. UAT Receiver MenuFigure 3.
Page 151 and 152:
SoftkeyFiltered Masked MenuHighligh
Page 153 and 154:
SoftkeyFunctionAltitude Same as men
Page 155 and 156:
Menu Control Functionsaved file.9 U
Page 157 and 158:
Menu Control Function12 NIC13 Uplin
Page 159 and 160:
Figure 3.1.4.4.1.3 illustrates the
Page 161 and 162:
SoftkeyFunctionType Same as menu co
Page 163 and 164:
SoftkeyFunctionType Same as menu co
Page 165 and 166:
5. If all devices enabled in the co
Page 167 and 168:
10. If the scenario terminates, the
Page 169 and 170:
LatitudeLongitude-90 to 90 degrees-
Page 171 and 172:
Stop at Scenario Duration 0 to Scen
Page 173 and 174:
Identification CodeStatic (STAxxx)
Page 175 and 176:
Note: That for all intruders the lo
Page 177 and 178:
Figure 4.2 - VNC Viewer Connection
Page 179 and 180:
5. TEST CONFIGURATIONSTTG-7000 User
Page 181 and 182:
TCAS/Hybrid Surveillance/ITP Versio
Page 183:
TCAS Coordinated RA Test Configurat
show all

TTG-7000 operation manual - AvionTEq

Create successful ePaper yourself

Delete template?

Save as template?