TTG-7000 operation manual - AvionTEq

Figure 3.1.1.2.3 – TTG-7000 Internal Network Change Settings MenuEnter the IP address desired for the internal DSP connection. The TTG-7000 will set the gatewayaddress to the same IP Address, and will internally set the DSP IP address and will communicate theaddress to the DSP module when the operator presses the “Set” Softkey. The application software willcommunicate the new address to the DSP, reset the connection, and reboot the DSP. This process willtake a few minutes. At the end of the process the application software will reestablish communicationswith the DSP using the new IP Address. On every future reboots the current IP address will be used. Ifthe operator wants to return to the factory setup, enter the same screen and press “Factory Setup”.The application software will start the previously mention process with the IP address set to192.168.0.1.TTG-7000 User’s Manual Page 2290-7000-0001 Rev E