TTG-7000 operation manual - AvionTEq

10. If the scenario terminates, the Scenario softkey will return to the off position. If user wants toterminate the scenario before the total scenario time, change the Scenario softkey to the offposition.3.2.10. How to Setup a Dynamic Mode S Intruder1. Go to the TTG-7000 Main Menu.2. Press the TCAS softkey to display TCAS Main Menu.3. Press the Scenario softkey to display the TCAS Scenario Menu.4. Use the Scenario Time combobox or softkey to enter the scenario time.5. Set the number of dynamic intruders to at least 1 using either the Number of DynamicIntruders combobox or softkey.6. Press the Intruders softkey to edit the intruder information. Select Mode S TCAS Only theIntruder Mode combobox or softkey to display the Dynamic Mode S Menu.7. Use the controls on Dynamic Mode S Menu to enter the information for your Mode S intruder.This screen is similar to the static, but allows the user to enter a velocity, vertical speed, andtrack direction.Dynamic Mode S Minimum ParametersParameter Default Selection (Range)Tx Channel Gen A Gen A, Gen C, or Gen DAltitude 1000 -1000 to 126700 feetBearing 0 0 to 359 degreesRange 0 0 to 160 NmiLatitude-90 to 90 degreesLongitude-180 to 180 degreesVelocity 0 0 to 2000 knotsVertical Speed 0 +/- 32576 ft/minTrack 0 -180 to 180 degreesReply Power -20 -20 to -90 dBm (Low Power)1 to -69 dBm (Hi Power)Reply Antenna By Altitude Bottom, Top, Both, Alternating,By AltitudeSquitter Power -50 -20 to -90 dBm (Low Power)1 to -69 dBm (Hi Power)Squitter Antenna Both Top, Bottom, BothStart at 0 0 to Scenario DurationTTG-7000 User’s Manual Page 17090-7000-0001 Rev E