TTG-7000 operation manual - AvionTEq

Menu Control Functionsaved file.9 UTC Time GPS. If enabled uses the UTC time from the GPS source input on externalI/O BNC #3. If disabled, the Touchscreen provides the DSP and FPGA with the UTCtime.10 UAT MSO Steps. The separation between UAT messages.11 Sweep Control for UAT#1. If enabled then the UAT messages will change everysecond by the sweep step until the MSO reaches the interval.12 Sweep Control for UAT#2. If enabled then the UAT messages will change everysecond by the sweep step until the MSO reaches the interval.SoftkeyFunctionLoadLoads a scenario.SaveSaves a scenario.ResetResets the scenario menu.UATsIllustrates the target definition for selectedUAT transmitter.Scenario Start/StopAllows starting and stopping a scenario.Scenario Time Same as menu control item 1.UAT RX1 DynamicsNumber of Dynamic targets in UAT#1UAT RX1 StaticsNumber of Static targets in UAT#1UAT RX1 SweepUAT#1 Sweep EnableUAT RX1 Sweep RateUAT#1 Sweep Step in millisecondsUAT RX1 Sweep IntervalUAT#1 Sweep Stop in millisecondsUAT RX2 DynamicsNumber of Dynamic targets in UAT#2UAT RX2 StaticsNumber of Static targets in UAT#2UAT RX2 SweepUAT#2 Sweep EnableUAT RX2 Sweep RateUAT#2 Sweep Step in millisecondsUAT RX2 Sweep IntervalUAT#2 Sweep Stop in millisecondsCapture Same as menu control item 6.Static Test Mode Same as menu control item 7.UTC Time GPS Same as menu control item 9.UAT MSO Steps Same as menu control item 10.Re-Compile After Load Same as menu control item 8.Note: When defining targets automatically the Touchscreen software starts at MSO 752 and spaces thetargets at the specified MSO steps.Note: In order to transmit UAT messages and the runtime to function after a start of scenario, the TTG-7000 needs the PPS signal from the GPS on external I/O #1 to function. User can also provide a 1 Hzsignal on external I/O #1.TTG-7000 User’s Manual Page 15590-7000-0001 Rev E